WDF530PLYB1 Whirlpool Dishwasher - Instructions

Repair was easy. After readjusting the dishwasher so that it wasn't leaning forward (it still leaked) I replaced the Door Gasket. Pulled one end out about 2 ft and pushed in the new one as I pulled the old one out and pushed the new one in. Came out and went in easy, just used a big screw driver to slighting push the new gasket in to make sure it fit snug. Fit, Form & Function was all correct. Works like a sharm, no more leaks and door does fit snug when closing. All good.

Repair was simple. Pulled out the old gasket and pushed in the new one.

Ordered Rinse Aid Cap and received the next day. Placed in the dishwasher Rinse Aid Cap position and locked in. A perfect fit.

remove screws on both sides of panel remove old panel remove sound insultion and install in new door using two clips on door hold door in place install screws and your done

Ordered the gasket on line. Received gasket in 3 days. Removed old gasket by pulling out in one piece. Pressed the new one in with my fingers and it fit perfectly and now have no leaks. Very easy fix.

cap was replaced

Old gasket was broken in places and old. Installing the new one was easy- no tools required. Just pull out the old one and press in the new one. Washer still leaks because door does not close all the way- need to figure out how to get it to shut tight. Maybe the latch is loose or worn.

Installed brackets

We had to pull the dishwasher out the get the heating element brackets loose underneath. We had to put the new heating element in and then we had to figure out which code to program in to make it reset. the last one listed on the installation instructions was the one that worked. I think it was heated dry, normal, heated dry. It would be very helpful if the reset instructions were put in the manual by whirlpool. I am very pleased with my part that I ordered from PartSelect. It came within 2 days of placing the order.

Remove blown high limit therm.and replace with the new high limit

remove 12 torxhead screws from door cover remove cover remove 6 screws from dispenser unplug harness and remove dispenser and rubber curtain. just reverse this and done. hardest part is unpluging harness with fat fingers

Googled the problem. Found a really good video about how to fix it. Ordered the part from PartSelect and it came in a couple of days. Son and I fixed it and had it up and going in a little more than an hour. The biggest problem was getting it disconnected from the water, drain and power and then hooking it back up. Old fat guys don't do well lying on the floor with their head under the sink - was why I needed son. Works now just like brand new. I highly recommend PartSelect! Don't know what it would have costs to get a repairman to do it but figured our labor saved us a couple hundred $. Yea!

very simple - pulled the old one out and install new door gasket no tools needed

Remove old seal. Clean area. Test fit new seal (it snaps into a slot). Starting at middle top, install seal by snapping into slot. Will have small excess at bottom of seal. Make sure it curves to follow bottom of door. Trim off excess seal. Shut the door. Aha! Success.

Bought a new baskrt