SVD48600P Jenn-Air Range - Instructions

Flipped off breaker and removed oven door and pulled built in stove out so the back panel could be removed. Unplugged the sensor then removed the two screws securing the old sensor inside the oven and installed new sensor. Put stove back together and installed back into counter top, re-installed oven door, flipped on the breaker and oven works like new.

Replaced the long Oven Sensor but have not resolved the root problem. Oven still will not reach required temperature. Bottom element becomes red hot, but turns off and will not start again.

The hardest part was taking out original light bulb because screws on shield where hard to unscrew after all this years . The old bulb vent out leaving neck in socket. It took narrow electrical pliers to get neck out .The generic appliance bulb did not fit and had aluminum neck ,not recommended for brass sockets in ovens.Putting new light bulb in was not the problem.

1. Unscrewed glass cover on bulb
2. Removed old bulb
3. Screwed in new bulb
4. Replaced glass cover
5. Mixed drink & baked cupcakes

Replaced the pans with the new ones which
arrived within a week.
Very happy with the service, stove top looks like new!

removed the old by pulling it out of track and replaced it with the new filter

just as stated before. Remove old burners from plate and reattach new burners.

see example. that's just how it went. easy. not really worth reporting.

I turned off the breaker for the oven. Then I unscrewed the 2 screws holding the element in and pulled the element out. I unhooked the wires from the element and put the new element in. Reconected the wires, pushe it back into place and replaced the 2 screws. Turned the breaker back on and it works GREAT! Way easy!!! ...even for a girl!

First turned the breaker off. Then I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. Reconnected the wires the new element, slid back in nd reiserted the two screws and tightened it all up. Flipped the breaker back and back in business.

I used a pair of plyers to remove both items and pushed new items in holes. Job complete

Removed two phillips head screws, pulled the element out until the prongs were exposed, pulled off the wire connectors and removed the bad element. After plugging the wires onto the new element, I pushed it back in and replaced the two screws. Easy job! Your web site is wonderful!

First I disconnected the power at the breaker box.
Then I removed the two screws that hold the element in place. I then pulled the old element out about 3 inches and disconnected the two wires. Then connected the two wires to the new element, pushed it back into place, then fastened in place with the two holding screws. Reconnected the power and tested and all worked fine.

Just plugged them in and reset the door,.

Just great.

first I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires then I took new element and plug the wires in it pushed the element back in place and replaced the two screws