RL635T Amana Microwave - Instructions

I ordered the part on Thursday and received it the following Tuesday morning.
Taking the cover off the bottom of the microwave was really the biggest part of getting this done. There are a couple of special screws on the back that a regular screwdriver won't fit into, but I got them off with a pair of needle-nose pliers.
Unplugged the motor, took out one screw, lifted off the bushing inside the oven and just reversed the process to install the new motor. Piece of cake!
Putting the cover back on is the most time-consuming part, do it in the right order and finesse it.
Food is going quietly around now!

I downloaded the repair instruction as directed by your group and proceeded to complete the repairs. The wife had gone shopping so I was able to pull the unit from the wall and made the motor change quickly. If she were there to supervise I would still be doing the repairs. It was simple to search for the parts and order the material. I received the parts in about two days so this really impressed me for the delivery time. If I were to complete any other repairs on appliances my first stop would be to your location. Thank you for saving me from buying a new unit.

My husband took the plastic cover off and took out old bulb and screwed in the new one. Then put the cover back on.

First I removed 4 screws at the bottom of the microwave that holds the cover in place. Disconnected power at the front of the microwave with the 4 pin connector. Disconnected 2 wires at the motor. Removed 2 screws and took out motor. Put in new motor, reconnected 2 power wires and then the 4 pin. Put cover on with 4 screws. DONE. Total time: 7 minutes. (I took my time at this because I like to do it right the first time.) I saved $40.00 on the motor ordering it on-line and received it in less than a week. Thank You! I cannot say it enough, Thank You! Thank You!

removed bottom panel removed old motor and replaced

Unplugged the MWO from the receptacle. Cut the access plate from under the MWO, unscrewed and removed the old motor. Unplugged the two leads from the old motor and plugged them onto the new motor, screwed the new motor in place, secured the access plate with a tek screw. VOILA, MWO again.

very easy

Screwed in light bulb and glass protector

I pulled down the wire around the glass cover. . . Released on end of the wire from its holder being careful to not let the glass cover drop. Unscrewed the bulb and replaced with replacement. Easy, easy.

Received the part the day after ordering. Appreciated the quick service and repair took less than a minute.