RF26VABBP/XAA Samsung Refrigerator - Instructions

Placed lower spring leg in hole first. Manipulated upper spring leg into upper hole with needle nose pliers.

replacing broken french door spring.

Held spring with needle nose pliers and slipped into place

Show how to fix it on YouTube so that helped a lot. I ordered a new spring gave all the correct information and the spring was too big that showed up
lol so had to go to Plan B an modified the broken spring lol works great now

Partselect made the repair process incredibly easy by linking a how-to video that explained exactly what to do. Without the video, I was trying to take the whole washer apart, but the video noted a convenient opening that provided easy access.
This is my second experience with Partselect, and I am definitely a fan. How you can maintain a stockpile of parts for so many appliances (as well as providing installation guidance for at least some items) is remarkable. Thanks.

YouTube the video on how to replace the ice maker. Unplugged the fridge, one screw was removed to open a small cover panel to access where the ice maker was plugged in, unplugged the ice maker, pushed a small locking clip and pulled the old ice maker off the keyhole slots holding it in place removing it from the fridge. Did the steps in reverse and reinstalled the new one. Plugged the fridge back in and reset the fridge by holding the energy saver and alarm button on the front door simultaneously for 8-10 seconds until it beeped. Took a few seconds and the fridge reset

Used a pair of needle nose pliers and replaced the spring.

had to replace the spring on the Mullion door . the how to video helped however the demonstration shows putting the spring on in the opposite way that my door calls for, so just I turned the spring around and done, other than that easy as pie.
thanks
Chris F.

Replaced the spring on my French door refrigerator
Was super easy

after receiving spring installed spring in seconds. Thanks partselect.com Ryan Cappell

Lifted out the broken part and replaced with new spring.

pushed new spring in.

Extremely simple, remove the old tray brackets and snap the news one in place. Put just enough pressure till you here them click in place.

(1) Set ice production to OFF from the front panel of the refridgerator. (2) Inside the fridge, remove the screw holding the panel covering the cable for the ice naker assembly. (3) Remove the panel. (4) Disconnect the power cable of ice maker. (5) Holding the assembly with one hand, release the locking clip of assembly housing, and slide assembly forward until it is free. (6) Remove the ice maker assembly. (7) Install the new assembly by reversing the previous steps. (8) Reset the ice maker by pressing the reset button and holding it for at least 8 seconds. The first time the ice maker is primed with water, there are 2 chimes. (1 High , 1 Low).