PGP990SEN1SS General Electric Cooktop - Instructions

I unscrewed the burners which was three screws per burner then removed gas control knobs and pulled up range top and un hooked the old module and replaced it with the new one two screws hold it in place and connected it the same way the old one was and put range back together and now it works perfect and saved me over $250.00 and part only coated around $40 with shipping great parts seller and I highly recommend partselect.com very easy fix thanks

Replaced Spark Module and adjusted igniters

Unplug the the electrical plug from outlet, removed the stainless steel top cover by removing 8 screws with a Philips screw driver, removed the old 4-burner ignition switch harness and replace with the new harness, then reconnect wires to the spark modulator. It was very straight foreword. The problem was remedied.

( I will note that in problem solving). The two components had to be ruled out for the burner to fail was either the spark modulator under the cooktop or the 4- burner ignition switch harness witch is located under the cover where the knobs are. The switches are one unit and if one goes out you replace all four. It requires no tools they slip out and snap back in the stem of the knob once the cover is removed.

I ordered the spark module and replaced it which was veru simple, plugged it in and it sparked only now and again. I finally said forget it and it has now stopped sparking but for how long I do not know.