MFI2067AES Maytag Refrigerator - Instructions

I snapped the cover plate to the filter open. Pulled the filter down and twisted counter clock wise to take filter out. I installed the new filter in by inserting the filter and tuning clock wise to secure the filter. I flushed the water for about two minutes and then allowed it to be put back into service.

I first change the board behind the touch pad on front of ref. That controls switching from ice to water and temps. Problem ended up being the actual touch screen itself. Part select was great helping with parts and return first part and shipped touch screen out asap.

Followed the video, 5 minutes later new piece installed. Unfortunately, the new plastic is like the old and the same defect could easily recur. thanks

After watching the Video on how to replace part, I got to work.. Was a piece of cake to do. Just a few screws and the job was done. I figure that I saved about $125 by doing this easy job myself.

I replaced the broken part. There was one bolt to loosen with a nut driver. I disconnected the original wiring harness, reattached the new harness and reinstalled the hinges, which simply slide into place. Then I reinstalled the small bolt I had removed with the nut driver. The job was with no problems.

Found "pegs" either side of drawer found "holes on side of lid pushed holes on side of lid onto pegs.

I simply snapped it into place, removing the protective covering during the process. Although the cost of the part was higher than expected for a simple piece of clear molded plastic, the whole job took about two minutes total. And, moreover, the part arrived two days earlier than I anticipated.

Remove pantry drawer, lid, crisper drawers, glass shelf above crisper drawers and shelf holders. Unscrew the 3 hex-head screws that attach the end cap to the side of the fridge. Very carefully pull the end cap away from the side about a centimeter. The end cap is attached to a moving vent piece for the crisper drawers which makes them in to a big L-shape. The vent piece is snapped in to the back panel of the fridge, so those two pieces must be removed together. You need to carefully unsnap the vent piece away from the back panel while holding the entire end cap piece as well. Go slowly and feel your way through it. It is easy if you don't rush. After removing the two pieces that make a big L-shape, detach the vent piece from the end cap piece. Attach the vent piece to the new end cap piece, re-fit it all back into the back panel of the refrigerator and reattach the screws.

after following instructions of previous posters, the hardest part for me was reinstalling the deli drawer lid. I was told it had to flex a little to get it on both hinges but mine didn't flex at all so I put on the left hinge and then put the right hinge on and put the right side pantry end cap in all as one piece. That worked easiest for me.

Ordered the left and right side parts. It took 4 time for them to send me a left side. They keeper sending the right side. It turned out that the wrong part was in the wrong ben. After they sent me the correct part it only took about 20 min to fix my refrigerator.

I popped the broken panel out and installed the replacement.

Placed in window and pulled out sliders.