LSE2700W Jenn-Air Washer Dryer Combo - Parts

Light Bulb - 7W

★★★★★

★★★★★

(5)

Sold individually. This bulb is a 7-watt appliance incandescent light bulb. This appliance light bulb is two inches long. It is used for many clothes dryers. You will need a Phillips screwdriver and n... Add to cart

Drain Pump

★★★★★

★★★★★

(18)

This washing machine drain pump is intended for use with automatic washers that have been manufactured since 1958. The pump itself is made of plastic, though it does come with a metallic belt pulley. Add to cart

Rubber Foot Pad

★★★★★

★★★★★

(1)

The leveling leg pad or foot pad fits over the leveling leg on your washing machine. The foot pad is designed to protect your floor and keep the washing machine level and in place. This foot pad is ju... Add to cart

Idler Shaft Retaining Ring This idler shaft retaining ring is well under an inch long and is made of metal. Add to cart

Tub Bearing Kit

★★★★★

★★★★★

(1)

This kit is used on 2-belt washers. It is recommended to change the seal kit at the same time. The tub bearing kit fixes issues with leaking, loud noise, excessive shaking/moving or if your pump is no... Add to cart

Roller Shaft Hex Nut This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers. Add to cart

Adjustable Leveling Leg

★★★★★

★★★★★

(1)

If your washer shakes or vibrates loudly when it reaches its max speed, make sure the 4 levelling legs are even. Adjust the legs so that the machine is level, and tighten the locking nuts on the legs ... Add to cart

Siphon Break Connector Kit

★★★★★

★★★★★

(14)

This plastic siphon break comes with a metallic clamp and gasket. It is used with many washing machines. Add to cart

Idler Arm Screw Sleeve

★★★★★

★★★★★

(3)

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer. Add to cart

Outer Tub to Pump Hose

★★★★★

★★★★★

(17)

This hose connects the outer tub to the pump of your washing machine. It is twelve inches long and all black in color. This hose is made entirely of rubber. Add to cart

Hose Clamp

★★★★★

★★★★★

(2)

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installat... Add to cart

Damper Pad Kit

★★★★★

★★★★★

(11)

This damper pad kit is used for base support. It comes with three six inch damper pads, two little tubes of lubricant. NOTE: This part will need adhesive to stick it in place. Add to cart