LDF7810WW LG Dishwasher - Instructions

parts were not exact match with original, even though ordered from schematic. had to bend the replacement part slightly so it would fit into holder pieces. this took about 10 minutes as I was trying to be careful not to break/cut the coating (which would then lead to rust again). Once the piece was bent, just snapped the rack into place.

Service tech diagnosed problem to the main PCB inside the door; his parts supplier indicated that the part was no longer available. We checked with PartSelect and they indicated that it was available as a special order item. We ordered it and shortly thereafter, the service tech contacted us with a part number for a substitute. Again, PartSelect had it available and this one in stock. Canceled the special order item and ordered the substitute. PartSelect followed through with email notifications. Part arrived within two days but the wrong model had been sent inadvertently. Joelle with PartSelect straightened it out and we had the correct one in two days. We installed it in about 30 minutes using an electric screw driver. Very easy! It helps to take a picture of the old part before taking it out to make sure the new one gets installed the same way and the wires tucked under as before. Joelle did a fantastic job verifying that the correct part would be shipped and followed up with the part return and all charges getting credited. Dealing with PartSelect was an excellent experience; will keep them in favorites list for all do-it-yourself appliance repairs.

The connector assembly connects to a spring to hold the door from falling down. You need to disconnect the power cord, the water line and the drain hose before you move the dishwasher out the kitchen counter. There are several screws that hols the dishwasher in place top, side and bottom. Removed all screws then pull the dishwasher out very slow. Take the side panel by un-screwing all the screws around the panel in my case where five screws (two in the front so you have to open the door to get to them). You need to keep the door down to connect the assembly to the door bracket and the go through the pulley then to the spring, very easy. Put the side panel back and push the dishwasher in place use the same screws and reconnect the hose the water line and the power and you are done.

I disassembled the upper parts of the pump housing and installed the new gasket. It seems to work fine now.

Check the motor and discovered roughness when you turned the shaft. I assume there was a bearing problem. I ordered a new motor from part select and upon the replacement washer is working great! Thanks part select, my part arrived in a timely manner and you guys saved me approx. $500. Thanx again. Richard Sansom

removing the dishwasher from under the counter I accidentally broke the mounting braket, to investigate/discover the door lift cord had frayed and broken. Parts were easy to locate and the costomer service was friendly. Installation was a breeze and perfectly intuitive. Not a Problem. thanks for being there, hiring a repairman would have been expensive.

pulled the dishwasher out, removed the side panel. It was very easy to replace the connector once the dishwasher was out and the side panel was removed. There are about five screws to remove the side panel. I replaced the unbroken connector on the other side since I had the dishwasher out.

Undo screws holding dishwasher in place, two screw just inside door one each side, should be covered with plastic cap. Slide dishwasher out, there is a spring on each side of the door connected through the connector to the door and cabinet. Slide connector our, install new one, slide disher back in, reattach screws holding dishwasher in place and your done.