LAW2400AAE Maytag Washer - Instructions

I found this website and it was the only reason I was able to fix the washer leak. I was about to go out and buy a new washer and dryer combo. Found the part after googling it and this website also had video on how to replace the washer seal kit. The drawings allowed me to see what the problem was and the video helped me know how to change the seal kit. I never would have known about the left hand threads on the tub nuts. I used a short punch to free nut instead of the spanner wrench which I didn't have. Otherwise repair went exactly as shown. I will always use this site to fix my appliances from now on.

even though i could have have ordered the spring that broke i took the easy way out and ordered the assembly it took less than 15 minutes to get done, and now the wife is happy and now i'm happy too.

Watched the installation video on the website and used exactly the same technique. Belts came off easily as did the pump assembly. Installed the new pump and belts and adjusted the pump belt tension to 1/4 " when squeezed together. Replaced the front panel and moved washer back into position. The pump noise was gone and there were no leaks. Easy job.

searched on line for the part.you guys had a very informative video looked how simple it was i purchased the part i needed and the rest was history thanks you guys are great saved me around 140.00 bucks. for about 15 minutes worth of work

just removed old base assembly with nut driver on one screw and put new base on .

pulled out washer from the wall tilted back towards the wall. removed front panel by pulling it out at the bottom. .removed belts by spinning the pulley .similar to taking a bike chain off. cleaned all pulleys with a degreaser 409 etc. springs are under the motor. slide motor away from you. remove springs with needle nose pliers from the front. to install new springs hook them to the rear of the motor first. fish them under the motor then grab them with needle nose pliers and hook to the front of the bracket. you could also tie a fishing line to the front of the spring and pull it thru that way. install belts [very easy]. did not need plastic guides. i did not install

Love these older machines... Easy simple and straightforward. Lay the product front up on a small 2 X 4. Remove front cover, (two phillips head screws near bottom). reach under hand roll off both belts,, check belt numbers to ensure old belt numbers with new belts. Rolled on new belts, checked tension, per enclosed note. Ajusted belt tension via the pump. replaced front cover and screws. Install unit, (be sure to level it) Time to Rock and roll.

I followed the step by step instructions on the video and it worked to a (T). You guys are the best. Thank you for all your help. Sincerely Eddie .

I am not going to describe the repair. The video that Part Select has on their website is exactly how our repair went. Very simple. This is the second time we have used Part Select. They have saved us a lot of money on repairmen or new purchases. I would definitely use them in the future. The videos are so easy to follow anybody can make the repairs. Also, the delivery company not only misdelivered the part but, they damaged it. When I called Part Select about the part being damaged, they immediately sent out a new part without any questions. Why aren't all companies this awesome?!

I watched the video and everthing went pretty well. The only problem I had was removing the Clamp Nut. My Washer is more than 10yrs. old so there is a lot of water and lime build up. I use a Cole Chisel and a Ball Pen Hammer to break the Clamp Nut. Because you can dispose of it anyway a new Clamp Nut comes with your Mounting Stem/Tub Seal Kit. The Tub wrench comes in handy for removing the Mounting Stem and to reseat the Mounting Stem. You are also going to need the Tub Wrench for reseating the Clamp Nut. You can order a Tub Wrench online there are various web sites.