KUDW02FRSS4 KitchenAid Dishwasher - Instructions

Removed access cover off very bottom of unit with nut driver. Located water intel valve. Placed hand towel under partvto be removed. Then remove water inlet valve with nut driver part is held on to unit with one nut head screw. With plires removed wire attached to water inlet valve. Then used wrench to remove water line and pliers to remove fill line. Reinstalled new water inlet valve opposite of way removed it. I am a 36 year old woman ifbI can do it so can you!

Just took the new one out of the package, put it in the dishwasher door where the rinse aid goes.

Disconnected the water and drain lines, pulled the washer out of the cabinet cavity. At that point, the work area was fully exposed. Then just a matter of removing the old assembly and replacing with the new. Stretching the spring so the other end of the cable could be attached to the door was the only part of the project that took a little bit of effort. It took more time to disconnect the water lines and pull out the washer than replacing the broken parts on each side of the door.

Pulled dishwasher out went down looked at problems ,saw both springs out of place and disconnected from door. Rewatched your video . Went to work one problem I did not realize the door had to be down to hook cable plastic attachment to door . Looked at video again saw door had to be down hooked up done !

Removed under countertop screws and lower trim plate. Retracted levelers to clear slate floor. Could only pull unit out about 8 inches, so had to reach in blind to remove and reconnect link ends from springs. Other than my 1 year old Newfoundland pup 'helping', no problems. Parts were perfect fit, just like in the video.