KUDI01FLSS3 KitchenAid Dishwasher - Instructions

Checked to see if top spinner was clogged. All ok. Wanted to see if water was flowing from bottom. Checked a video to see how to remove parts to access lower area. Saw the problem immediatley. Clogged Chopper screen due to broken chopper blade. Ordered new chopper assembly and got it in two days. Five minuted to install. Washer works like new.

The repair was extremely easy as the video was extremely helpful. A word of caution, make sure to watch the entire video before you start. I only watched the video 1/2 way through (as I thought I knew it all). When I (thought) I completed the repair, when I opened the door, polley's went flying everywhere. I finished watching the video and saw that I also had to use the bottom bolts, not just the top bolts. Nothing dangerous, but extremely funny. I then completed the repair W/O a hitch.

Very easy to replace the two tension cords. Saved a 75.oo service call. The Video was very helpful.

Unhook electrical/water supply, removed dishwasher, flip upside down, Remove wire connector from motor, remove bolt from motor, turn motor and remove, install new motor in reverse process.

Pulled Dishwasher out, turned off power. Did not have to disconnect any hoses or electrical, because when I did the original installation, I left plenty of slack, so as to be able to pull it out. Next, tipped it on it's side, unplugged the harness, undid the bolt, turned motor 1/4 turn, pulled it out. To, re-install, just reversed the process. About 1 hour.Followed Excellent instructions on video. Was very impressed with delivery time. Only about 30 hours, from the time I ordered, to receiving part. Reg. ground.

Estamated time was 15 minutes, it took me about 3 hours because everything was so cake up with detergent. Parts would not move. Video very helpful

I noted that the replacement kit had two large rollers now vs the original that had only one that rotated, the other fixed. Also, the plastic attachment for the door arm was more simple. It was very easy to pull out the unit, attach the spring end hook to the rear of the dishwaser frame hole, attach the new cable, thread it over the two rollers and pull the spring using the cable to attach to the door arms. Less than 20 minutes to install both sides.

Disconnected the water line after removing all the screws which hold the dishwasher in place. Slid the unit out around 24 inches and removed broken Door balance pulley and replaced both sides with the new door balance set . replaced both sides to ensure an even and balanced tension when opening and closing the door! Over all a relatively easy repair. Just be certain you disconnect the water line if you do not have enough slack when pulling out the unit from the cabinet. Good as new!

The video was excellent as was my experience when I replaced my ice maker.

Pulled out, put on it's side. Take pump off and put new one on and put all back together. Very easy. Video was helpful also.

put new one in

Followed the video and changed it out in 20 minutes which did not fix the problem entirely, but I went back to the list of symptoms and watched a video on exchanging the Chopper assembly. I disassembled the interior and found broken glass and wire and string restricting the rotational functions. No replacment was necssary here, but a good cleaning was in order. This made it run like new and the glasses came out shiny again. These step by step videos have even made me think about becoming an appliance repairman. LOL! This is about the 8th time I have had success with Part Select. I have had no failures. Thank you for giving away all the secrets. YOU DEFINITELY HAVE SAVED ME AND MY FAMILY TONS OF MONEY!

Removed under countertop screws and lower trim plate. Retracted levelers to clear slate floor. Could only pull unit out about 8 inches, so had to reach in blind to remove and reconnect link ends from springs. Other than my 1 year old Newfoundland pup 'helping', no problems. Parts were perfect fit, just like in the video.