KUDA23HYAL0 KitchenAid Dishwasher - Instructions

I looked in the bottom of the dishwasher after browsing the website regarding possible solutions. When I removed the bottom spray arm I noticed three screws missing from the pump housing. The loose pump outlet had allowed the seal to push out. Ordered-Normal shipping on the part.

Watched "PartSelect" video showing how to remove the old tube and install the new one. Also read what others said about warming the tube with a hair dryer to make the rubber more flexible -- as you had to stretch the rubber to get it to go over the plastic parts that it attached to. I ordered the part around 3 PM and received it around 10:30 AM the next day. Excellent service!

I reviewed your video and followed the steps, I appreciate the video. I used the tools described in the video; it was a simple process. Thank you Parts Select. .

Turned off electric to machine.Removed water with shop vac, Removed lower panel, removed drain hose from check valve and garbage disposal. using shop vac removed blockage from drain hose. Reconnected hose turned on electric cycled dishwasher. Didn't work. Turned off electric, removed water, removed basket, sprayer arm, pump cover, used a six point deep socket to hold impeller while removing 1/4 in. screw. Removed the impeller and found the problem.The lower impeller shaft is broke. removed separator, chopper blade and spring, removed pump cover and broken drain impeller and lower seal. Cleaned all old parts and installed new drain pump kit. Replaced spray arm , basket . Turned electric on, cycled the machine one time. Checked for leaks, replaced lower panels. Put away tools. Your video was very helpful. Your service was great. I received the parts the next day after ordering them. thank you. thank you.

Remove old tube and slip new one in its place. Tube is flexible enough to do this easily. Make sure the side of the tube with the small hole faces down.

Had to remove all the chrome trim around the door and the changeable front colored panel to access the bi-metal switch. Replaced the switch but the soap door still does not open.

slipped the part on by hand

I could not find a 90 degrees 1 inch car wrench and by them the impeller head wish is plastic was all run down so nothing will hold it, finally, I heat up a flat screw driver and cut the impeller near the head whit the help of a hammer , and them I could grab it with a pressure wrench and loose the screw up. finally the fix when fine and is working good. the parts are just the ones I need it. Thank you.

I had called an appliance repairman...I gave him the model #- he called me back in 2 seconds and said it was too old.. no parts available.. wanted to charge me $100 to come and look.I found parts select online. the part came in one day... and my handy man/put the new bracket on.. the dishwasher was put in new in 1991 and still works like a charm..thanks thanks

My model was DU7600XS0. I disassembled according to the video and the parts diagram here. I found a piece of metal, a pebble, and a wrecked drain impeller. I cleaned out all the debris and began reassembly. I found that the chopper blade shipped with this kit has a lip and will not fit over the metal drain impeller sleeve on this model. It needs to, or else it will not screw together properly and the impeller will not be able to turn. My old one was undamaged, so I used that instead. Also, the large black wash impeller has a shaft that is longer than the original part and because of that, it would not screw on. Again, the original wash impeller was fine, so I used the old one. I replace the gaskets and screwed everything else back together. It works great now. No water is left after the cycle anymore and the sound it makes is back to normal. Money well spent on this kit!