JVM1350WW02 General Electric Microwave - Instructions

I searched in the website, I got the picture of the frame you had available for the Model and copied it in my computer. The frame had been placed on a graph paper. I counted the squares on the graph paper, measured the one I had and it was the same measurement. So, I ordered it.
We were able to install it perfectly well. WOW! THis is a lot easier than going around town looking for one and not finding it!
Thanks!!!

I used the similar screws of my own for temporary until I found parts from PartSelect.com to buy. After I ordered and when it arrives, I just simply replace the missing screws and screwed them in to get LCD TV and LCD TV Stand together firmly without a problem which is much better than the wrong screws I used for temporary.

used the part I requested and a few extra bolts...job well done!

easily replaced. parts arrived quicker than suggested. thanks

Found blowup drawings inside unit, which helped identify what I had to remove. Had neighbor assist in lifting unit from wall mount, unit slides easily from rails once top bolts are removed. Pay attention to where all the screws go as you remove them, some inside assemblies will have to be removed or loosened. A good guideline to go by is all black screws hold internal assemblies, the bronze screws go in the back side and the chrome screws go on top, sides, and front of the unit. I was able to lift unit back on rails without any assistance.

removed access panal, found soft switch as discribed on your web site. removed and replaced.

I slipped the new saucer out of the box and placed it in the microwave. I was very disappointed to discover that the new one didn't fly like the old one.

One screw is exposed and the other lies beneth a plastic trim. The trim was easily pried off with a screw driver and the handle replaced. I reused the existing screws. If you need some order them because they don't come with the handle.

It was great...Thank you for having the part available...

Removed old handle and replaced it with new one very easy but I thought very expensive

Remove light cover. Replace bulbs Note. Light bulbs are 40W,Too much heat for bulbs & sockets

Took screw holding lens cover out, dropped cover down, unscrewed old bulb, screwed new bulb in socket. Screwed cover back in place. This is the third bulb in this socket, the other bulb is original.

This is the second time the handle broke, so I learned from the first time -- although it was more than 10 years ago since the last repair. To familiarize myself, I checked out Youtube videos about replacing this part. I learned that I needed to pry off the frame on the inside of the door -- which was easy -- and I onlly had to pry it off about 3/4 of the way in order to access the bottom screw of the handle. The top screw is accessible without having to pry off the frame. Easy DIY project.

Remove top screw.Remove seal on inside around glass which lets you get at bottom screw.Unscrew bottom screw in handle. Put on new handle and screw it in firm only. Replace seal around glass. Done

Easy as can be. Removed one screw on the glass cover, removed two burned out bulbs and reinstalled two new bulbs, reinstalled the cover and all is well now. The best part - my 'supervisor' is happy that she can see to cook again!