JSD2588AEA Jenn-Air Refrigerator - Instructions

Easy repair - Don't over complicate it. 1) Flip up ice bar to stop making new ice. 2) Pull out the complete ice bin/tray. 3) shut freezer door while you work on the ice bin. 4) All you need to do is remove the 4 screws holding the ice bin holding tray to the front of the Ice cutting section in the front. 5) Screw drive can then be pulled forward to remove the old/broken white drive cap. Just replace the White Drive ring, put the drive screw back into the ice bin tray and re-install the 4 screws. 6) When re-inserting the bin, you may have to twist the screw drive slightly to re-align with the motor bracket in the back of the freezer. Suggestion: throw out old ice because if it is wet or slightly melted, when you put it back in the freezer the ice will freeze/clump together into a large ice clump; not cubes. Also dry out the ice bin so there is no water to freeze up or create a new jam when the ice bin now re-freezes.

turned off the water supply,disconnected the power from icemaker to the back wall,loosened the two screws on the top,and one screw on the bottom.removed old icemaker.took the bale off,to put on the new icemaker.removed the wire harness from the old,to put on the new icemaker..saved over $200 for the repairman,had a full tray of ice in 6 hours.(watching the video,helped)!!!!!,very thankful for your service,as most of my appliances are all in that ten year period,i will be ordering more as needed.

Followed the video exactly. Replaced both valves in less than 1 hour. No more leakage. Very simple!

Pull out plastic cover #13of refrigerator part discription (temp. control and light socket), snap out old light socket and replaced with new light socket. light is now working.

Shut off the refrigerator. removed the food from the top shelf and lowered the shelf for more room. opened up compartment at the top of the refrigerator, located the bad defrost part un plugged the part and plugged in the new one. Buttoned everything back up. 2.Squeezed the Air return cover to remove it and replaced it with the new one. Everything works perfectly!!

Empty out freezer loosen two top screws and took out bottom screw. Lifted out ice maker and unplugged wire. Took bailing arm and plug and put on new ice maker and reverse the process. Had ice in three hours and no leaks.

So easy to repair. Parts select offered the most likely solutions and repair parts to fix this problem. Ordered the ADB and replaced it in a matter of minutes. Saved myself at least 2-300 dollars by doing the repair myself. All seems fine. Its been almost a week now and the freezerad fridge are both working famously!

Removed wiring from old ice maker and install on new. With 2 screws all ready in place hung ice maker on them. Attach wire connector into socket and install bottom screw to hold ice maker. Tighten top 2 screw and put wire guide in place. Drop wire guide down and ice started in 10 mins

The only hard part of this rapair is getting the auger off the motor. I wasted a lot of time before driving to auto supply store and buying a set of thin needle nose locking plyers so I could get a true grip right behind the auger. Once I had that, it was just a matter of a lot of brute force and a second pair of big locking pliers I already had for grip on the auger.