JSD2488GEW Jenn-Air Refrigerator - Instructions

Pull out plastic cover #13of refrigerator part discription (temp. control and light socket), snap out old light socket and replaced with new light socket. light is now working.

Empty out freezer loosen two top screws and took out bottom screw. Lifted out ice maker and unplugged wire. Took bailing arm and plug and put on new ice maker and reverse the process. Had ice in three hours and no leaks.

Removed wiring from old ice maker and install on new. With 2 screws all ready in place hung ice maker on them. Attach wire connector into socket and install bottom screw to hold ice maker. Tighten top 2 screw and put wire guide in place. Drop wire guide down and ice started in 10 mins

Since it was at least 10 years old, I thought that it was time to replace it, and that a major repair with a technician would cost me same as buying a new one. Just for curiosity I searched for the cost to have someone repair it, but Partselect showed up, and pointed out my problem and how to fix it. Was not sure, so for 90 dollars including shipping I bought the run capacitor and the overload relay kit just in case. The video to replace the run capacitor was simple, still, my friend at work who is an electrician warned me to take extra precautions not to touch both terminals an use gloves, so I did, and while I was there I replaced the relay kit. It was a bit different than what the instructions said. But the logic was simple an clear: remove the old piece from the 3 pin terminal of the compressor, and on the same manner and orientation, (no way to miss it) place back the two new piece relay. Plug back in the two cables. The extra cable-adapter, you will find important since the old relay had a different male-female size, and this small cable will adapt from the small female size to the bigger male size in the relay. The cover did not fit as suppose, but I still place it back to cover relay from outer elements. As soon as I remove the old relay, I knew that that was the problem, it was full of broken pieces when it burned out. I placed back the frige cover connected and BINGO, within an our I was cooling down my beers!

The only hard part of this rapair is getting the auger off the motor. I wasted a lot of time before driving to auto supply store and buying a set of thin needle nose locking plyers so I could get a true grip right behind the auger. Once I had that, it was just a matter of a lot of brute force and a second pair of big locking pliers I already had for grip on the auger.