Models > JSD2388AEA > Instructions

JSD2388AEA Jenn-Air Refrigerator - Instructions

All Instructions for the JSD2388AEA
841 - 845 of 845
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
1.running warm and noisy selenoid 2.freezing vegetables
Shut off the refrigerator. removed the food from the top shelf and lowered the shelf for more room. opened up compartment at the top of the refrigerator, located the bad defrost part un plugged the part and plugged in the new one. Buttoned everything back up. 2.Squeezed the Air return cover to remove it and replaced it with the new one. Everything works perfectly!!
Parts Used:
Air Return Cover Adaptive Defrost Board
  • Frederick from Tacoma, WA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Ice maker drips water, making a blob of ice in the compartment
Empty out freezer loosen two top screws and took out bottom screw. Lifted out ice maker and unplugged wire. Took bailing arm and plug and put on new ice maker and reverse the process. Had ice in three hours and no leaks.
Parts Used:
Replacement Ice Maker
  • Charles from Metairie, LA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
freezer barely freezing. fridge side warm
So easy to repair. Parts select offered the most likely solutions and repair parts to fix this problem. Ordered the ADB and replaced it in a matter of minutes. Saved myself at least 2-300 dollars by doing the repair myself. All seems fine. Its been almost a week now and the freezerad fridge are both working famously!
Parts Used:
Adaptive Defrost Board
  • David from Lompoc, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Old ice maker element burnt out
Removed wiring from old ice maker and install on new. With 2 screws all ready in place hung ice maker on them. Attach wire connector into socket and install bottom screw to hold ice maker. Tighten top 2 screw and put wire guide in place. Drop wire guide down and ice started in 10 mins
Parts Used:
Replacement Ice Maker
  • David from Bonita, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
case plastic broke where motor attaches
The only hard part of this rapair is getting the auger off the motor. I wasted a lot of time before driving to auto supply store and buying a set of thin needle nose locking plyers so I could get a true grip right behind the auger. Once I had that, it was just a matter of a lot of brute force and a second pair of big locking pliers I already had for grip on the auger.
Parts Used:
Ice Enclosure
  • David from Maryland Heights, MO
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the JSD2388AEA
841 - 845 of 845