First remove the screws around the inside perimeter of the door. These require a special hex driver. Take off the inside plastic liner of door. Peal off the old Insulation Foam Strip and replace it with the new strip in the same location. Make sure the wires are off to the right side. Replace the door plastic liner. Done. The Insulation Foam Strip really acts more like a loose gasket to keep spashing from creeping under the door and drippin out on the floor.
Ignitors kept clicking after flooding the stove, had to unplug any light manually
We had flooded the stove from boiling and after that the ignitors kept firing. We had to unplug the unit and light manually. Not sure exactly what the problem was, but I replaced the module and harness. Very easy. 1. Unscrew hex nuts, you can buy a hex nut set anywhere. 2. Pull out ignitors. 3. Cut or peel away caulking, if you did this. 4. Carefully lift lid off and set aside. 5. Unscrew module and scree back on. 6. replace harness exactly as you find it. 7. Make sure all colors go back into module as originally set. 8. place lid back on and replace the ignitor. Really very easy. Thank you!
Remove burner, replaced gasket and spark igniter. On bottom of grill replaced missing rubber foot protectors. Initially I thought I would have to splice into the igniter wire however, after watching the video on repair, I discover all I had to do was carefully pull the wire out of the igniter from the bottom and push the wire into the bottom of the new igniter, then replace the burner into position and tighten the trox screws. It was a simple repair and everything is working fine.
Grate Foot Have 8 For My Stove And One Breaks Every Now And Then
This was and always will be an easy fix, all I have to do is get my ice pick and pick the broken rubber part stuck in the hole if it does not break clean and fall out. Not much more I can say about this simple problem.