Quick Question!

Have you ever purchased from PartSelect.com before?

Models > JE1160WD04

JE1160WD04 General Electric Microwave - Overview

Get Parts and Repair Help for JE1160WD04

If you know the microwave repair part you need, you can browse the list of all parts on the JE1160WD04, or you can search by name or part description. You can also find your part by where it is located on the JE1160WD04 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the JE1160WD04

[Viewing 1 of 1]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Light Bulb and Socket

This light bulb is sold with the socket. The bulb is 120V and 25W.





This part is used to generate microwave energy/heat.


Cooking Tray

This tray rotates in your microwave ensuring more even temperatures.




Thermostat Cavity


Turntable Motor


Micro Switch


Primary/Secondary Switch

This is sold individually. Your appliance would need 2 of these.


High Voltage Capacitor

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Original lamp burned out.

  • Customer: Rudy from Huntington, IN
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 68 of 83 people found this instruction helpful
After looking up on the computer a schematic of the unit, all that was needed was removing four screws to remove the top and side cover which was one piece.
Next was removal of electrical connection to burned out lamp, then removing burned out lamp and installing the new lamp and reconnecting electrical connection.
Job was complete after reinsta... read more

Microwave oven was completely dead.

  • Customer: CHARLES from LAKE ARIEL, PA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 27 of 37 people found this instruction helpful
Continuity checks showed the flame sensor was open. Schematic notes it opens at 217 degrees and closes at 30 degrees. Removed sensor and placed in freezer for twenty minutes. Tested sensor and it was now closed, reinstalled and microwave worked normally. Ordered new sensor in case the original is operating at too low a temperature. read more

The display was off and no buttons were working

  • Customer: Michael from Astoria, NY
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 17 of 22 people found this instruction helpful
I took the cover off and followed the electric current to see if it got as far as the display.
I did not get past the thermostat shut off where the current stoped. I jumped the thermostat and the unit worked. The part was so inexpensive that I decided to replace it rather than try and freeze the old one in hopes of "reseting" it. read more