Models > HMV1630DBWW > Instructions

HMV1630DBWW Haier Microwave - Instructions

All Instructions for the HMV1630DBWW
1 - 10 of 10
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Had to replace charcoal filter
Open the front cover by pushing it at the top (where it says “Push”), lifting up and pushing back on top edge of the old filter. Pull it out. Installing the new one is basically just the reverse of those steps! That simple.

Old filter did seem to be a little thicker (filter material), but the new one was the exact same dimensions, so it went in properly. Wish the filter material was white, so you knew just how dirty it was actually getting. But... :-D
Parts Used:
Charcoal Filter
  • Jared from SIERRA VISTA, AZ
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
14 of 19 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Tripping circuit breaker, broken micro switch locking pin
1. Unplug unit
2. Open door, remove two screws above the top trim piece, slide and remove trim.
3. Remove screw behind control board and top left corner, then release from position.
3b. Unplug all wire terminations and set control panel aside.
4. Remove two screws securing latch board, lift and rotate board out of position, remove three micro switches, xfer monitor switch actuator from lower pin in old board and insert in new. Install new door switches and reverse procedure to complete repair.

Note 1. Take care to located new latch board so holding tabs line up, pass through frame, and openings for door tangs line up with openings in frame before securing with screws.

Note 2. A long magnetic screwdriver is helpful.
Parts Used:
Microwave Door Latch Housing
  • Charles from CLAYTON, NJ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers
11 of 15 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Charcoal Filter replaced
Open the microwave door, push the press and release door that is located across the top of the oven. Remove and replace filter, close access door, close microwave.
Parts Used:
Charcoal Filter
  • Glenn from SAN ANTONIO, TX
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
15 of 38 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Mirowave door latch
While installing a filter in my brand new never been used microwave range hood combo I snapped off the top door latch with my elbow. After a few expletives I search You Tube and found it was a simple fix. I ordered a replacement latch from this site. It arrived in three days and it took 5 minutes to fix.
Parts Used:
DOOR LATCH
  • Fernando from WEST CHESTER, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
5 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Carcoal Filter indicator light on
Loosened screw on top of filter
Removed and replaced filter
Parts Used:
Charcoal Filter
  • Thomas from RIVER EDGE, NJ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
3 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Warning light came on to replace
Ok. Surprised I was sent a damaged part. Box was intact but the aluminum frame was bent. Looks like I received a factory reject. I was able to make it fit
Parts Used:
Charcoal Filter
  • Doug from CHALFONT, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
microwave door latch that was broken at bottom catch hook
I received replacement and followed youtube instructions to replace door latch mechanism. Very simple and only required a screw driver. works fine. Total time: less than 20 minutes. Wife and I are happy as I did not have to buy new a Microwave.
Parts Used:
DOOR LATCH
  • Eugene from COLUMBIA, SC
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The door wound not shut right or lock
Used the puddy knife to open up the door and then used a screw driver to change the old part with the new one. That easy
Parts Used:
DOOR LATCH
  • Matthew from SAN TAN VLY, AZ
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Needed filter
Open main door at the top is small door open take out old filter and replace newone
Parts Used:
Charcoal Filter
  • MS Bettie J from RIVERDALE PK, MD
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
noisy microwave turntable
I never knew why it made noise till I looked at the break down on this web site and found it was missing rotating ring since it was new. But unfortunately, I never received turntable ring which was ordered on 12/19/2022 now its tracking says Wednesday, 12/21/2022
9:36 AM
In transit
CAMP HILL, AL it has been stuck there all this time still not on its way to Florida. I don't understand did fedx put on southwest airlines?
Parts Used:
ROTATING RING Assembly
  • mark from SUMMERFIELD, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
1 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the HMV1630DBWW
1 - 10 of 10