GT2628PEFW Maytag Refrigerator - Instructions

use kitchen knife to pry out. replaced switch assemble and pressed back into place. Could not have done this with out help from previous customers. Thanks

First I removed all food items from above and in the Meat drawer. Then I removed the meat drawer from the slides and placed it on the counter. Then I removed the shelf that the slide rails are attached to and turned it upside down on some folded towels. Next I inserted a screwdriver (Flat tip) between the bracket and the rail I am about to remove. This released the locking tabs. Then I slid the old rail back and it popped off. I install the new rails without the screwdriver inserting them in the slots and sliding them into place. Next I reinstalled the glass shelf back into the fridge. Finally I inserted the meat drawer back into the new slides. The Job went rather easy, just take your time and don't pry the screw driver too much, just enough to clear the locking tab.

I unscrewed the support and replaced it with one that I ordered. It was fast and easy.

Pried out old part with screwdriver. Unplugged. When new part came, just plugged it in and pushed the part into place.

I removed the ice catcher from the excellent packaging, rinsed it, and placed it on the counter next to the fridge. I opened the door the the freezer and placed the ice catcher under the icemaker. I lowered the arm on the icemaker and closed the door to the freezer. Then I opened the door to fridge, took out a Guinness, popped the top, and sat down to savor my success.

Removed old ejector arm and installed new part.

This repair was quite simple. The rails basically slid off from the the drawer. I then had to screw on the rack wheel and replace the rails by guiding the notcc into the hole and slide it back. The whole process to replace both sides took only 10 minutes.

Disconncted power, pulled plug on disconnect, loosened 3 ice maker attach screws, removed ice maker. carefully removed old broken part, to understand reasembly. Reinstalled new water fill & bearing part.. hung icemaker and tightened attach screws. Reattached electrical plug.. turned on power, it all worked. .took about 45 min to remove, 15 min to reinstall. Right tools needed re disassembly AND ASSEMBLY

Eased the putty knife under the edge of the switch housing and pried it off. Pulled two wires off the old terminals and hooked them onto the new one and reinstalled into the refrigerator body.

ordered a new shut-off valve. arrived in 5 days. installation had to wait a couple more day for i had to order a new compression nut. the reason i had to order a new nut was because the original nut was made of teflon and stripped easily when i tightened it to make a leak proof.joint. the new nut arrived in two days and was installed readily being that it was made of brass and consequently did not strip when i tightened to make a drip proof joint. finished in approximately twenty minutes' the video that this site has on the internet was of great value.

Unplug refrigerator.
Pry switch out with putty knife
Remove two wires from switch
Attach wires to new switch
Push new switch into slot

Replaced with new rail & popped it into place

bulbs were not burnt out. received the new switch in a few days. watch the short video, was good to see how it comes out. used a putty knife to release the defective switch, removed wires put them on the new one and posed the new switch back in. Not bad Part cost $11.00 7 dollars shipping so for 17 bucks it works great. nice to see what is inside the refer!

We looked up the problem online with the model number of the refrigerator. We ordered the part and followed the video installation that was sent with the order and was found online prior to purchasing

I removed the old one and replaced with the new one. The right side one was quite easy whereas the left one took a longer time.