Quick Question!

Have you ever purchased from PartSelect.com before?

Models > GSS20IEPJWW > Parts

GSS20IEPJWW General Electric Refrigerator - Parts

All parts for the General Electric Refrigerator GSS20IEPJWW

Below is a list of all parts for the General Electric Refrigerator GSS20IEPJWW. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the GSS20IEPJWW
1-14 of 242
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$11.31

Temperature Sensor

This temperature sensor, also known as a thermistor, is used for refrigerators and freezers. The sensor sends the temperature reading of the refrigerator towards the control board....

$35.96

Ice Bucket Auger

When activated, the auger rotates and pushes ice out of the bin through the chute to the user.

$13.20

Defrost Thermostat

This defrost termination thermostat acts as a safety device to stop the evaporator coil from overheating, by turning off the defrost heater at the end of the defrost cycle. The the...

$21.46

Drawer Slide Rail - Right Side

The drawer slide rail for the right side is used for refrigerators. The drawer slide rail attaches horizontally to the refrigerator wall and supports the drawer so it can easily slide in and out. If the drawer slide track is broken, not sliding, or is not dispensing water, then changing the right side drawer can be the solution to the following problems. Make sure to unplug the refrigerator from the power source and make sure to wear gloves to protect your hands when installing. Refer to the diagram provided by the manufacturer for further guidance and instruction.

$19.42

Drawer Slide Rail - Left Side

When looking inside the fridge, this white drawer slide rail is located on the left side of the refrigerator. Rail ONLY.

$7.53

Dispenser Door Assembly or Flapper

The dispenser door assembly (or flapper) is what opens to release the ice once the lever has been pressed. This part mounts in the ice dispenser. The cranker no longer comes with this part. You can use the original crank. The crank is sold separately depending on the model number of the appliance. For this repair, all you will need is a Phillips screw driver and a small flat blade. Disconnect the power, remove the escutcheon from around the dispenser, lift up the control panel, disconnect all wire connectors, use a screwdriver to remove all four screws of the housing, and lift the housing out. You will now see the flapper: push the tabs that are securing it in place to remove the piece, install the new flapper by lining it up and snapping into place.

$159.28

Ice Maker

This is a replacement ice maker kit, it is used in the freezer section of your refrigerator. This particular model will produce seven round or crescent shaped cubes every cycle. Th...

$41.11

Dispenser Door Solenoid Assembly

This part is a possible option when ice door won't open or shut properly or when water is not dispensing.

$3.58

SWITCH LIGHT

The interior light of your refrigerator is controlled by a switch that is activated when the door is opened and closed. If your refrigerator light will not turn on, there could be ...

$255.22

Electronic Board

This board controls the operation of the unit. Note: This part has been updated by the manufacturer. It may differ in appearance but will function the same as the original.

$32.16

Condenser Fan Motor

This fan motor is most times used with frost-free refrigerators with a condenser coil. When the compressor runs, so does this fan, circulating air through the refrigerator grille, ...

$5.08

Bearing Slide

Sold individually.

$3.60

Evaporator/Condensor Fan Grommet

$2.58

Dispenser Light Bulb - 12V

Sold individually.

All Parts for the GSS20IEPJWW
1-14 of 242