Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Change filter
When removing existing filter you will experience some resistance at the 10-4 position which requires a little extra pressure to reach the 9-3 position.
REPLACED WITH NEW. HOWEVER, THE WATER FILTER INDICATOR STILL SAYS 'REPLACE'. THERE IS NO LEAKAGE, BUT IT APPEARS LIKE THE NEW CARTRIDGE IS NOT COMPLETELY INSERTED. I'VE TRIED REMOVING AND REPLACING THE NEW CARTRIDGE SEVERAL TIMES, BUT IT STILL SAYS 'REPLACE'. INCIDENTALLY, THIS WAS THE SECOND ORDER OF THE CARTRIDGE AND LAST TIME I GOT TWO, AND THEY BOTH FIT FINE! WITH THIS ORDER I GOT JUST ONE.
I read other suggestions trying isolate auger motor shaft with pliers while turning bar drive. needle nose pliers could hold the shaft. bar drive just would spin. so took the whole ice box assembly out (only 2 screws) and with a metal cutting blade used the sawzall to cut along the shaft. freed it up enough to then unscrew it from that point. Left handed threads by the way.
Water filter a bit stubborn but resolved. Other questions ~ see below
When reading instructions, I noticed it said to run water through the water filter. I don’t have a water dispenser ~ I only occasionally make ice. So how often should I change, Barely used. The red light will go on, can I just ignore it?
