Models > GLEB30M9FSC > Instructions

GLEB30M9FSC Frigidaire Microwave Oven Combo - Instructions

All Instructions for the GLEB30M9FSC
76 - 78 of 78
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
inner glass uncleanable
Took door apart, went online to partselect, ordered new glass, and put it back together. Oven looks like new. Makes sense to order the isolation as well when you do the repair
Parts Used:
GLASS
  • Krista from Newtown, CT
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
sparks and crackling sounds
Just slide the cover up a bit and it comes out. put the new one in place and slide down into place. done that's it.
Parts Used:
Waveguide Cover
  • Adrian from Tamarac, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Oven would not heat after running self clean
Googled the problem and found Oven Temperature Sensor and Main Terminal Block to be the most likely problems. Turned out to be neither. No parts were needed. Oven has a thermal overload switch on the rear upper left. Thermal overload needed re-set. To do so you have to remove the oven, remove the back and press the red button on thermal overload. Biggest challenge was figuring out how to remove the oven. Even with the installation manual it was not easy to fgure out. The instructions are misleading. You need a special tool. I used two hacksaw blades as a substitute, and slid them in to release the clips. Once you figure out how to get the oven out the rest is simple.
Parts Used:
Temperature Sensor Main Terminal Block Kit
  • Michael from Owasso, OK
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the GLEB30M9FSC
76 - 78 of 78