GFSL6KKYBLS General Electric Refrigerator - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Water filter needed replacement
Removed the old filter. Filled the new one with water and put it in theplace of an old one. Flushed the system with 1 gallon of water.
Parts Used:
-
Natalia from Mount Pleasant, SC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Evaporator freeze up
-
Peter from Homer Glen, IL
-
Difficulty Level:Really Easy
-
Total Repair Time:1- 2 hours
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Broken plastic shelf cover
-
Michele from Birmingham, AL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Poor water and ice taste, filter a few years old.
Very simple, I followed instructions sent with the filter. Twisted old filter clockwise 1/4 turn to remove. Filled new filter with water, lined up arrow on filter to arrow on refrigerator, and then turned 1/4 turn counterclockwise. Filter raised and seated itself. Wiped few drops of water from refrigerator shelf.
Parts Used:
-
David from San Antonio, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
The plastic on the vegetable tray shelf was cracked
The repair was so easy. I had to take out all the food. Then I was able to easily lift the shelf out, and put the new shelf in and replace the vegetable drawers.
Parts Used:
-
Karen from Medford, MA
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
Was this instruction helpful to you?
Thank you for voting!
Filter needed replacing
-
W Craig from Diamondhead, MS
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Evaporator Fan Failure
Disconnect power to refrigerator, Removed all upper shelving, slid the draw assemblies out 12 inches to gain access to lower retaining screws using my power screwdriver. Removed three lower retaining screws and two screws that hold the center shelf rail. Then removed the cover assembly by pulling out and down from the bottom of the assembly until I could access the connectors for the fan at the upper left hand corner. After releasing the lock tabs for the electrical connectors I removed the assembly from the refrigerator cabinet. There was an excessive amount of ice/frost buildup due to the fan failing so I used a blow dryer set on low to thaw the ice from the evap coils and related wiring and sensors. Once thawed and free from ice, I reversed the procedure to install the new cover. The procedure would have only taken about 10 minutes if it were not for the ice buildup. I would recommend letting the frig thaw first if you have another place to store the food. Overall, very easy to install.
Parts Used:
-
Fran from Mount Vernon, IA
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
replaced filter
-
donnie from metairie, LA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
on the french doors my granddaughter kept turning the inner seal bar when the door was open and when we went to close it it was in the wrong position and eventually the upper hinge broke
I took a small straight screw driver and popped the cap case off, removed old hinge and installed new hinge and snapped the cap back in place.. took all of 30 seconds
Parts Used:
-
david from bridge city, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Spring broke
Installed new spring pin and spring. Took only 2-3 minutes. It was more difficult to get the correct part since the spring pin was the only number listed in the part diagram and I actually needed the spring and had to call customer service to get the correct part number.
Parts Used:
-
Sharol from Culdesac, ID
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
replace water filter
-
Richard from Waynesboro, PA
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Change Filter
-
GREGORY from SACRAMENTO, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Ice and Water Filter needed replacement
It was easy and fast, like changing a light bulb. The directions were clear and easy to follow. Thank you.
Parts Used:
-
Irene from Tigard, OR
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
did not need adapter
exactly as the instructions.......never did see anything about replacing the adapter...therefore i did not
Parts Used:
-
terry from fort worth, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Ice Maker assembly was leaking into cube tray and fusing all cubes together.
Remove Ice maker tray and remove one screw on left side holding wire harness cover on. Remove wire harness cover, disconnect wire harness, pull out Ice Maker Assembly. Install new Ice Maker Assembly, plug in new wire harness & screw harness cover back on.
Parts Used:
-
James from RSM, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!