Models > FDB989GFC2 > Instructions

FDB989GFC2 Frigidaire Dishwasher - Instructions

All Instructions for the FDB989GFC2
661 - 675 of 688
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
damaged bottom rack/rust
Just slid out the old rack and pushed in the new one. As a 70 year old lady with NO mechanical skills, it took me longer to get it out of the shipping box than into the dishwasher.
Parts Used:
RACK ASSEMBLY,LOWER,GREY
  • Wilma from York, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Old door latch broke
Remove phillips head screws that surround cosmetic cover around handle. Turn off power at breaker. Remove with torx bit, old handle assembly. Unplug four wires that connect it to wiring harness. Plug those same four into new latch assembly. Reattach to the door with old torx screws. Reattach cosmetic cover with phillips screws. Remove old gasket. Install new gasket per included instructions. Find middle mark on gasket and press in. Install bottom of gasket into nitch at bottom of each side. Press gasket in lightly in 4-5 places on each side. Shut door and lean against it to seat gasket. Repeat until gasket is fully seated.
Parts Used:
Door Latch and Gasket
  • Aaron from Denver, CO
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Dishwasher was leaking water onto the floor
I viewed a very short video on how to replace the lower gasket on the website which was extremely useful. I then ordered the part via standard shipping and it arrived very quickly. I used the flat head screwdriver to gently loosen the old gasket which has mineral buildup on it and was stuck into place. Sliding the new one in was a snap. This was one of the best sites as you could search for the part by describing the problem. I would definitely use it again!
Parts Used:
Dishwasher Bottom Door Gasket
  • miles from hoboken, NJ
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
something had jambed in bottom of dishwasher causing lower spray arm to jamb and break pins on other 2 parts then it came off assembly and lodged against warming coil and melted
Took all 3 parts off, 5 minutes, went on line did search for make and model and parts distributor, ordered parts by part numbers, received parts very quickly, 5-10 minutes to install. Very easy tp locate parts with all the diagrams online and very helpful. Easy to use ordering system and very fast processing.
Parts Used:
Lower Spray Arm Lower Spray Arm Support Lower Spray Arm Support
  • Michael from Elkhart, IN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Water leaking from the washer
R&R the tub gasket and the door gasket. Repair not effective, it still leaks.
Parts Used:
Dishwasher Tub Gasket - Gray Dishwasher Bottom Door Gasket
  • Charles from Mount Pleasant, TX
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Water leaking from bottom center of door
Ordered a bottom gasket and replaced it. Started dishwasher and had same leak. Found out that the lower spray arm had a hole in it from the heating element and was spraying water directly at lower part of door. Replaced lower spray arm, problem solved!!
Parts Used:
Dishwasher Bottom Door Gasket
  • James from Pollock Pines, CA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers, Wrench set
Was this instruction helpful to you?
Thank you for voting!
Rusty dishwasher racks
Repair was very easy and the price was the best part. I called around to local appliance repair shops and they quoted prices from $318 to $440 for two replacement racks. I spent less than half my lowest quoted price at PartSelect. Also to note, customer service was excellent. One of the racks I received had some of the white coating missing, and they replaced without hassle. I would highly recommend PartSelect.
Parts Used:
RACK ASSEMBLY,LOWER,GREY RACK ASSEMBLY UPPER
  • James from Braintree, MA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Lower Spray Arm Was Damaged And Not Washing Properly
Plied off old spray arm and pushed downard on new one and it snapped in place. That was very simple and took less then a minute.
Parts Used:
Lower Spray Arm
  • WENDELL from MESA,, AZ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Racks were corroded
We just pulled the racks out, re-used the silver ware holders etc. and re-attached the center piece to the upper rack.
Parts Used:
RACK ASSEMBLY,LOWER,GREY RACK ASSEMBLY UPPER
  • Rosalyn from Tempe, AZ
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
Was this instruction helpful to you?
Thank you for voting!
dishes not drying -- water not heating
Took bottom panel off dishwasher -- used stubby screwdriver to remove bracket from old thermostat, intalled and connected new thermostat, replaced bracket -- easy. Parts schematic on website made locating and replacing part very simple.
Parts Used:
High Limit Thermostat
  • Judy from Miles City, MT
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Original part came loose & fell against heating element. Subsequent damage made part unusable/
Snapped new part in place in about ten seconds.
Parts Used:
Lower Spray Arm
  • mary from bonita springs, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
spray arm fell over and melted on the heating element
Very simple, pop old one out and pop new one on.
Parts Used:
Lower Spray Arm
  • Jean from Deatsville, AL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Lower spray arm had fell over and melted it caused the dishwasher to leak.
Snapped the arm right on and no more leaks.
Parts Used:
Lower Spray Arm
  • sharon from Lebanon, TN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
water leak at bottom of door
Pulled out bottom gasket, inserted new gasket. Max about 5 min. Pulled out tub gasket,cut new gasket to match old gasket and pressed into tub.Max about 10 min. Spent more time putting kick plate back on.
Parts Used:
Dishwasher Tub Gasket - Gray Dishwasher Bottom Door Gasket
  • Raymond from Port Clinton, OH
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
Was this instruction helpful to you?
Thank you for voting!
bottom rack at numerous rust spots
I was leery at first as the cost of the rack was minimal but when I received it I was more than pleased. Just slid the old one out and rolled the new one in! No muss or fuss and it fit perfectly
Parts Used:
RACK ASSEMBLY,LOWER,GREY
  • Marcia from Payson, AZ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the FDB989GFC2
661 - 675 of 688
Back to Top