This is a bracket, but it may also be known as a dishrack row clip, or simply a tine clip, and it is used in conjunction with your dishwasher. The purpose of this part is to fasten to the rack and the...
The roller assembly is attached to the upper dishrack of your dishwasher. This is what allows you to easily move your dishrack in and out. The wheel may become damaged over time and will not allow you...
This is an OEM dishrack roller assembly that fits on the lower rear of your dishwasher rack. This part is sold individually. Check the opposite lower dishrack assembly before ordering in case it needs...
This gasket is a seal for your dishwasher and prevents leaking from occurring. The gasket can become worn down over time and you might notice some discoloration. This indicates a replacement is necess...
Spray arms rotate and spray water to clean the dishes inside the dishwasher tub. This part is located beneath the upper rack. The spray arm is meant to spray water and detergent forcefully over the di...
This clip is designed for use in your dishwasher. If you notice that your original clip is damaged, or the dishwasher is not cleaning dishes properly, you may need to replace it. The clip snaps on to ...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
August 16, 2021
What year is this model ser. Th00910139
For model number EIDW6105GS1
Hello Mike, Thank you for your inquiry. Based on the model and serial numbers you have provided, this appliance may have been manufactured in March of 2010 or February of 2020. The exact date of manufacture for this appliance may actually be found printed right on its model and serial number tag. Look for a 4-digit date code (eg. MM/YY) printed on the identification label. Hope this helps.
Was this helpful?
Thank you for voting!
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Something went wrong. Please try again later.
Your Question Has Been Submitted!
Our experts will send you an email as soon as your question has been answered.
Disconnect from power Unscrewed 4 phillips screws from top of outer door. Unscrewed 2 screws each siide of door. Lower outer door section drops away. Note wiring sequence on dispenser, then disconnect wires. Unscrew 6 screws on dispenser and lift dispenser out.
Place new dispenser in place (note orientation), ann fasten in place with screws, remembering to replace wire retainer on left lower screw. Reconnect wires to dispenser correctly. Slide lower outer door over tabs and secure with the 4 side screws. Ensure lower door is up under control panel and secure with the 4 top screws.
Fill dispenser with detergent, reconnect power and test run while enjoying a cup of tea in celebration of a job well done..
The only difficultpart was to figure out how to remove the stainless cover from the door. Seems it slides upwards after screws are removed. After that it is self explainatory and goes back together in 5 minutes.
After turning of the power to dishwasher, I opened the door took of the two bottom screws on both sides of door. Closed the door and front panel just slide off. Then I took a picture of the dispenser to make use I could figure out how to put the wiring back together. Removed the six screws holding it in place and popped the dispenser out. Easy .. popped new dispenser in and lightly put all six screws back in ,wired it back up after checking my photo. Closed the door ,slid front panel back on opened the door put the 4 screws back in that hold the front panel .Turned power back on and Boom!! All done.. Not bad for a girl...