EF42BDCBSS Hardwick Refrigerator - Instructions

Viewed the repair video. Removed covering. Replaced limit switch, control board, and solenoid. Very easy repair!

Removed screws from upper hinge. Removed washer from door stopper on bottom hinge. Lifted door off lower hinge. Replaced bushing.

Took about 15 minutes and cost less than $12. Service call alone was going to be $70.

I watched your online video on how to take out the old filter, and then to replace it with the new filter. It was as easy as on the video. Thanks!

Removed the ice brucket,
Removed the light shield by releasing one screw using a nutdriver.
Replacing the bulb and reinstalled the light shield.

Your web site is one of the best and most helpfull service sites I ever used. Just wish that in the future you will ship parts overseas.

Removed screw onder on left side of ice maker shelf. Then removed shelf while disconnecting the wires behind. Removed selonoid and yolk and simply reinstalled in reverse order. The customer service was great because I first ordered the wrong part and was easily returned and correct part sent. If you are ordering and have questions call them. If you sense your agent doesnt have the full knowkedge you need I would ask for another one. This is why my original part was wrong. They handled my problem and I was pleased.
Alan

Instructions were great five minutes to remove and replace fan....Thank You............ saved big money

had to saw off the shaft to get the yoke off and tap the holes for the 8/32 screws. all holes should have been tapped by the factory. Other than these problems, everything else went pretty good.

I pulled the drive ring off of the icemaker and replaced it with the new part. Saved a $150 service call plus cost of part. It cost me a little over $11.00 and a repairman probably would have charged $30.

All work was done by hand. I removed the cover plate, unscrewed the existing water filter and screwed in the new one. I returned the cover plate to its original position and bled the air out of the line by running the water dispenser for a few minutes. It could no have been easier.

Removed by hand the old water filter and installed the new one.

Located the filter, removed the filter, installed the new one, reset the filter light on the front of the water discharge, and all is good.

I followed the video of your repair man. Made it very easy.Thanks.

repair&parts instalation was easy but troubleshutting difficult.

It was only the door but it wouldn't come out without disassembly of the entire dispensing section; this meant removing the front section and disconnecting 2 pcs from 3 wire harnesses...much more involved than I thought. The spring and strike were fine, but when I reassembled the unit it didn't work. The key was the mechanical connection with the solenoid. It is not obvious and directions would have been helpful. BTW unlike me, flip the power off. I got a good shock from the accuator.

Disconncted power, pulled plug on disconnect, loosened 3 ice maker attach screws, removed ice maker. carefully removed old broken part, to understand reasembly. Reinstalled new water fill & bearing part.. hung icemaker and tightened attach screws. Reattached electrical plug.. turned on power, it all worked. .took about 45 min to remove, 15 min to reinstall. Right tools needed re disassembly AND ASSEMBLY