ED5FVGXWS00 Whirlpool Refrigerator - Instructions

Simply follow the video instructions. Involves the removal of nine screws. to remove the old plastic sleeve cut the tube near the old thermostat and it slides of easily. Apply dish or hand washing soup to the new tube when putting the plastic sleeve onto the new probe. The hardest part is getting the end of the probe coiled to the right shape. Hey,` if I can do it with a broken collar bone, anybody should be able to do it.

only tools needed were my husbands hands. easily removed old filter and replaced with new one.

I have not broken it but afraid to force the ice new ice guide into position. Crisper drawer no problem . Thank you

replace drawe

Read the instructions, watched the video and followed the very clear instructions and lay out.

Repaired it using the video that you sent through email. Thank goodness for the video or would still be trying to fix it!

Removed the door (3 bolts on top). Removed the old plastic door closing cam on the bottom. Installed the new one. It was too tall (probably my fault), so I trimmed it with garden shears (it was a tubular piece of plastic). If you do this, be very careful, as the shears cut through the plastic MUCH easier than I thought. Popped the new one on, re-secured the door, and it works great now. Thank you partselect!

Very simple and straight forward

When I ordered the new auger drum from this website, I noticed a video that explained how to install the item. When I received the new drum, I went to the website and found the video. All I did was to watch the video and do what the repairman did. I did get a little confused when I noticed that the auger in the video was metal, and mine was plastic. However, upon removing the pieces as shown in the video, it became clear that the new auger drum would fit the same way the broken one had fit. After that, it was a snap to put the pieces back together.

the repair from the video was exact to a tee. Very helpful 100%.

Order new filter cap and filter ,remove old filter, follow instructions be sure to push new filter hard until it clicks!!

The installation could not have been any easier. First you will want to turn off the water supply and unplug the refrigerator. Next remove any shelves that are in the way of removing the old unit. Then you will remove the single 1/4" screw at the bottom of the unit completely and then loosen the 2 at the top (leave them in place as the ice maker sets down onto them). Next lift old ice make up and unplug the wiring from it. Finally reverse the process. It is worth mentioning that was forced to reuse the existing wiring harness as the old one was hard wired to the refrigerator. This presented no problem as the new ice maker is making ice .

simple twist the existing filter and pull, remove puller cap and place on new filter , pushed in and twist to lock. Reset filter indicator.

Took it out and slipped the new one in.

Messed with trying to get cable assembly plugged in for most of an hour. Finally swapped cable assembly with the old one. Plugged right in. Finished in 20 minutes.