Models > ED2KVEXVQ01 > Instructions

ED2KVEXVQ01 Whirlpool Refrigerator - Instructions

All Instructions for the ED2KVEXVQ01
1111 - 1116 of 1116
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Floating baffle and Ice bin auger drum were both broken and needed replaced.
The video of the repair that was on your website was extremely helpful. It showed in detail how to replace the parts item by item. I could not have done it correctly without the video. I believe anyone could have replaced these parts with your instruction video.
Parts Used:
Ice Bin Auger Drum Floating Baffle
  • Jack from Babson Park, FL
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
water leak under refigerator
My wife could have made the repair, I got on line, typed the problem in and PartSelect came up. The drawings were there as well as instructions. The part came, again with instructions and it took about 20 min. Good job guys.
Parts Used:
Water Inlet Valve
  • Ronald from Taylor, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
ice maker not working
Shut off water & electric.Remove 2 screws,cut water lines,unplug electric plug. Install electric plug,push water lines in.reinstall screws,hook up water line & plug in ref.Turn water on, ck for leaks.
Parts Used:
Water Inlet Valve
  • William from East Canton, OH
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Screw drivers, Wrench (Adjustable)
Was this instruction helpful to you?
Thank you for voting!
Water filter needed replaced
It was very easy just popped the old one out the new one popped right back in done in about One min .
Parts Used:
Whirlpool EveryDrop3 Refrigerator Water Filter
  • Violet from Aurora, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
The door would not close tight unless you gave it an extra push
Removed the old cam and put books under the door to hold it up. Follows instructions and really easy
Parts Used:
Lower Door Closing Cam
  • Cindy from Kenner, LA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Socket set
Was this instruction helpful to you?
Thank you for voting!
fridge too warm
remoove all the food and shelves out from the freezer section, remoove the light bulb lens ( 1 phillips screw) remoove light bulb, take out 6 srews on the back panel then slide out through the top with a slight bending curve motion, the bimetal thermostat will be clamped to the evaporator inlet, ( just after the cap tube) snap it off, then cut the wires about 2 inches from the stat, strip the ends about a quarter inch with wire strippers, same on the new stat, then use 16 or 18 gauge butt splices and crimp them , then reassemble in reverse order.
Parts Used:
Bi-Metal Defrost Thermostat
  • mike from ROSCOE, IL
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the ED2KVEXVQ01
1111 - 1116 of 1116