Quick Question!

Have you ever purchased from PartSelect.com before?

Models > E30GF74HPS2 > Parts

E30GF74HPS2 Electrolux Range - Parts

All parts for the Electrolux Range E30GF74HPS2

Below is a list of all parts for the Electrolux Range E30GF74HPS2. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the E30GF74HPS2
1-14 of 209
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$34.18

Temperature Sensor

The oven temperature sensor for your range may also be called a probe. The quick connect on this part may differ than your original piece. If the temperature sensor does not fit yo...

$5.56

Indicator Light Lens

This is a red indicator light lens for an oven that covers the indicator light for the surface element. The indicator light signifies when the element is on and heated. This part is sold individually. It is recommended to check other red indicator lights in case they need to be replaced because they often wear at the same rate. It is difficult to see the light without the red lens. This part does not include the light. If your light does not illuminate, you may want to consider ordering the light as well. Tools required for this repair are a 1/4 inch nut driver and a stubby Phillips screwdriver.

$8.93

ORIFICE

$123.18

Inner Oven Door Glass

This inner oven door glass, also called an oven heat barrier glass, is a transparent and heat resistant sheet of glass that fits into your oven or range. While containing the heat, the sheet of glass acts like a window so you can see the contents in the oven. This is an original part sourced directly from the genuine manufacturer. Wait to replace the glass until the appliance is cool to the touch. This part is sold individually, and contains the glass panel only. Glass panel is approximately 20 inches by 13 inches.

$6.73

SCREW

$46.03

Spark Module

This spark module or range spark module, is used in ranges and ovens. The spark module monitors and controls the spark to ignite the surface burner in a range. It does this by sending a certain amount of current to the igniter to produce that spark. If you are not getting any spark to the igniters then it is best you replace this part with a new spark module. To repair, first remove the access panel at the back of your range with a 1/4 inch nut driver to take the screws out. Next, disconnect the power harness that connects the range to the power cord to access the spark module. Take wires off using needle nose pliers and pull the spark module off the range. Match and hook up the wires to the new part. Refer to the manual provided by the manufacturer for further installation instructions and guidance.

$25.03

Power Cord Assembly

This cord supplies electricity to the range.

$9.51

ORIFICE

$36.86

SEAL

$8.55

INSULATION

$214.93

Flat Glow Bar Igniter

This flat glow bar igniter is designed for gas ovens. The function of the part is to ignite the gas to light the oven burner. If your gas igniter does not glow, or if it glows but ...

$11.59

FAN BLADE

$9.12

NUT

$38.64

BURNER

All Parts for the E30GF74HPS2
1-14 of 209