Models > DLW330RAW > Instructions

DLW330RAW (PDLW330RAW) Amana Washer - Instructions

All Instructions for the DLW330RAW
136 - 140 of 140
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Water leaking from under washer front corner.
I read instructions on how to change the pump. I unplugged the washer and then I took off the front panel.I removed the hose clamps and removed the two hoses from the pump.Then I removed the two front springs that hold the drum in place. Be careful because these springs are under tension. I removed the 4 bolts that held the motor to the tub. I unplugged the wires leading to the motor. I removed the motor. I turned the motor upside down and removed the pump and belt. I ordered a belt along with the pump because it was worn. It is best to note how the belt is installed. I took a picture before removing the pump from the motor for future reference if needed. Installation of the new pump and belt was not difficult. I worked the belt around the drum pulley and made sure it turned freely. After completing installation I ran the washer through a short cycle to check for leaks before installing the front cover.
Parts Used:
Spin Belt Drain Pump
  • Quentin from Topeka, IN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver, Pliers, Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
Water filled after machine off
Removed the plate screws. Found valve, unplugged wires, removed hose and replaced reattaching everything. Replaced plate. Done
Parts Used:
Water Inlet Valve Kit
  • Darcy from Merrill, WI
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers, Wrench set
Was this instruction helpful to you?
Thank you for voting!
Idler pulley bad, needs replaced
Repair went well using posted instructions. My advice is always replace pump as you will damage seal when pulling pump off shaft.
Parts Used:
Idler Pulley Wheel
  • Mark from Asotin, WA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Socket set
Was this instruction helpful to you?
Thank you for voting!
Washer Had No Cold Water
Took off part and replaced it very easy instructions.
Parts Used:
Water Inlet Valve Kit Single Washer Inlet Strainer
  • lucinda from trilla, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Water leaking under the washer
Removed old hose, drained the water from the hose. Put new hose on.
Parts Used:
Drain Hose with Rubber Elbow
  • Laura from Westfield, MA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the DLW330RAW
136 - 140 of 140
Back to Top