DLSR483EG7WW General Electric Dryer - Instructions

My dryer was making a grinding noise so I tore it apart using a screw driver, a torks bit and a pair of pliers. It took about 15min to get it appart. I found the idler pully was worn out and broke in 2 pieces. I ordered the new part along with a new belt, since I had it appart, and they arrived the next day. It took about a half hour to put the new parts in and put the dryer back together. Works great now. While I had it apart I cleaned the elements and greased the bearing.

I watched a video on PartSelect.com, opened up the dryer (that's the first time I had opened a dryer), found that the bearing was worn down, ordered the replacement parts for under $40, and fixed the dryer in just a few minutes. The whole process was much easier than I expected. I should have done it weeks ago.

At first I thought it was the belt but when I took off top portion of dryer I saw belt was fine. I got to this site and found source of noise was drum bearings from postings. I ordered the parts and much to my suprise had it working with 15 minutes. Web site was very helpful.

Pulled clip off and installed new knob

Watched video first, then diagnosed trouble. Went to internet for cost and avalible parts. Copied parts diagram. Very pleased with price and orderd parts assosiated with front drum. 4 days later parts arrived.

new handle just popped right in the slots

Thanks to the Part Select YouTube videos, I was able to determine how to disassemble the dryer without having to spend much time trying to fixure that evolution out, and I was pretty much able to troubleshoot what the potential problems (and fixes) were via the various Part Select videos (drum slide(s) install, bearing install). The only part that took a bit of time to install was the drum rear bearing. It is an easy install, but it was helpful to have my son hold the bearing from the back (outside) of the drum while I tighten the screws from the inside of the drum. Again, watching the Part Select videos beforehand is a must!

Replace the knob with new one

Had to tap three holes in the rear bearing to match the three attachment screws. Screw up with the part.

it was easy, it clip right on.needed to give it a little tap to get it in .

Followed the videos on this web site and found out how easy it was to replace the belt,drum glides and felt seals. I took my time and also completely cleaned out the gas dryer from all the lint. Thank you for the great prices, fast shipping and how to videos. Bill d.