DCSR483EA0WW General Electric Dryer - Instructions

removed the old broken handle, and snapped the new one in place, total time; 10 seconds.

Snapped on the new on the new one. all done

Unplugged dryer and pulled away from wall a sufficient distance to be able to stand behind it. Located the four screws located along to top of the dryer control panel. Selected the correct torx bit (not philips or slot) and unscrewed all 4 screws. Front of control panel rotated open such that the inside of the rotary start switch was visible. Removed broken switch by pushing down the catch tab with one finger and using the other hand to rotate the switch counter-clockwise about 1/4 turn (to the 9 o'clock position). Installed new switch by inserting in the same 9 o'clock position and rotating clockwise until the metal tab locked the stitch in place. Used a vacuum to clean out lint and replaced panel and securing with the 4 screws. Attached the new selector know by lining up with hole and pushing in. Took the extra 2 minutes unscrew the band holding the air vent and vacuum the lint out. Replaced the flexible vent by tightening the band. Carefully pushed back the dryer, ensuring not to kink the flexible vent. Plugged dryer back in. Worked like a champ.

I watched the installation video a of couple of times and followed the instructions. Two screws under the dryer door then the top comes off. Then two screws hold the front on come out. Unplugged the two wires to the switch. Removed the duct assembly. Cleaned up the door and snapped in the new duct assembly. Re-installed the door and then the top. Everything was easy - just like in the video.

Reviewed problems with the dryer on line and ordered the parts. The only problem is that it takes two types of slide bearings which I did not order correctly. The video was great and had no problem installing the parts.