Quick Question!

Have you ever purchased from PartSelect.com before?

Models > DCD330GB4KC

DCD330GB4KC General Electric Dryer - Overview

Get Parts and Repair Help for DCD330GB4KC

If you know the dryer repair part you need, you can browse the list of all parts on the DCD330GB4KC, or you can search by name or part description. You can also find your part by where it is located on the DCD330GB4KC by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for DCD330GB4KC parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Rear Bearing

Bearing Only. This part helps your appliance run as quietly as possible.


Drum Belt

Used to turn the drum.


Rear Bearing Kit

This kit comes with the rear bearing, shaft support, lubricant and other items required for the installation.


Drum Glide

Sold individually. There are some dryers that require 2 per dryer. They attach to the outer-most sides of the bearing.



This igniter is used for gas dryers. This part ignites the gas within the dryer.


Rear Bearing Shaft Support


Upper Felt Seal with Adhesive


Lint Filter


Lower Felt Seal with Adhesive


Bearing Bracket

This bracket is used on the drum bearing.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Loud rhythmic squeaking

  • Customer: Mark from San Diego, CA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Wrench (Adjustable)
  • 39 of 48 people found this instruction helpful
About a year ago I had to replace the front sliders. I had thought at the time that I should replace the belt and check the rear bearing, but I was in a hurry, and the wash was backing up, so I didn't do it. Oops. Within 6 months dryer started squeaking. Did I get around to pulling it out, and greasing rear bearing. Nope. Dbl oops.

Luckily on... read more

Loud screeching noises from the rear of the dryer whenever in was running.

  • Customer: Kenneth from Boise, ID
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 10 of 11 people found this instruction helpful
We unlatched the top of the dryer by pushing a screwdriver under the two areas where there were metal clips holding it down. We then removed the yellow clip screwed onto the top frame. We removed the front frame of the dryer by unscrewing the two screws holding the front frame on--one on either side. We didn't undo the wiring to the controls, we just kind ... read more

Dryer was not working.

  • Customer: Frank from Rochester, NY
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 6 of 7 people found this instruction helpful
Removed front and top panals to dryer. Installed belt over the drum. opened back air vent panal and installed belt to pully. Reinstalled back top and front panals. Done. read more