DBXR463EB0WW General Electric Dryer - Instructions

Remove & rplace switch

This was a very easy job. It was like snapping Lego pieces together. I ended up taking more time because I took the time to clean the orher parts while it was open. Took about 30 minutes total. Please make sure you know where the electrical wires are located at the bottom of unit. If you take the whole front panel off some of the wires may come off. There is not much documentation on the wiring so be cafefiul. Take a pic if you can. I watched the videos on YouTube from this site before starting. Just want to add that I am not a mechanic of any type. This is an easy job.

Found replacement part easily on website using model and serial number.Part arrived in one day, fit perfectly without any tools and dryer is functioning like new. Easy ordering process with excellent customer service.

unpluged dryer opened door took out 2 screws holding the top lid on took out 2 screws that hold the front on replaced parts and put back together. Dryer sounds brand new.

its very easy!! just pull or pry out the old handle clean surface snap in the new one! its that easy!! PS don't get to rough with the installation!!

Drum slide slots had worn so bad that i needed to replace the whole thing. I had already taken it apart before to change drum slides and knew it was a matter of time before the whole bearing was going to need to be replaced.

removed what was left of old door handle and replaced it with new handle. Snapped right in without any trouble, 30 seconds max.

just installed it

I checked out YouTube and found some really helpful videos from various appliance guys. The parts came fast and I knocked out the repairs in about an hour. Replacing the front and rear bearings was a breeze and no more squealing. Just like new

read and looked up the blown up picture of the dryer , got the correct tools and removed the two screws in the top of the dryer door , removed the top , removed the two screws on top going to the sides , then one screw in the front lower left side to allow the left side wall spread apart ,took the idler arm and belt off the motor shaft , picked up the drum with the belt and pulled it out forward. ordered the correct parts that were recomended . parts came the next day , instructions on your web page were awesome .. and it runs better then new !!!! thank you very much ! and i believe i saved a bunch of money !!

Timer Replacement: Disconnected power cable. Removed timer knob. Used Torx driver #T-20 to remove 4 screws on top of timer housing. Used flat head to pry up the locking mechanism and then used hand to rotate timer and lift out. Used pliers to remove connectors one by one and place move to new timer, and reassembled. Drum Components: Followed instructional video without any complications.

Went well. Excellent service on parts delivery .

I followed the provided video precisely. Made the job quite easy. My only problem is I'm 6'2", 275 lbs. with bad knees. Can't go at it exactly as shown in the video because I can't squat down in front of the dryer without pain. Called in a neighbor of smaller stature for him to come from one side, and me from the other. Worked flawlessly. Video is excellent. I do recommend wearing gloves and/or long sleeve shirt. I cut up my arms a bit, but that could have been easily avoided.

replaced the parts that had worn out

Removed 2 Phillips heads on front panel. Removed 4 hex heads on back panel controller. Took off lid. Took 2 Phillips screws on inside by door out. Lifted door off. Discovered on front seal housing 2.5 of 4 seals gone. Replaced front seal bearing and lower felt seal.. A must...vacuum at all the dust! Replaced the green and white seals. Put all back together. My 17 year old dryer is like new again and quiet. Did this for $37. Front seal housing was fine so could have did for $20. Also thanks part select. I ordered at noon on Monday and had Tuesday at 5pm.