CSX27DRXDAA Hotpoint Refrigerator - Instructions

The part came within 3 days. But it was only one cam. Part was described assembly so i thought it had both cams. I ordered the upper cam which attached to the door bottom. When I matched the new to the old --they were different. They looked the same until you put them side by side. Being the mechanic I am, I cut the rivet holding the assembly cam and pop riveted it to the old assembly. It was not difficult but annoying as I had the correct model (I have the original use and care guide book). I must commend PartSelect for their promptness.

Removed 4 screws from the old rusted ice bucket ( they hold the cover on) installed the cover and screws in the new ice bucket and installed the new unit in the freezer .

Ordered new Ice Maker from you and fixed the problem completely.

Followed the video, very simple

I watched the video on the partselect website once and completed the repair. Very easy!

The trim piece covering the opening of the dispenser is the first and most difficult part of the disassembly. Take care when removing this piece that it does not break.

just i took off the actuator and replace with the new one in 8 minutes.It was so easy.

Watched video on the parts order information page and did the repair. Very helpful made me feel like I could do the repair

First, depending on when you find out your problem, be prepared to toss out spoiled food. Unplug the unit. Since you must allow the ice build up on the coil to melt, be prepared for water. Use towels placed under the coil in the freezer to soak this up or it will end up on the floor. Remove ice maker bucket as the ice will melt, that is if there is any. In my case the defrost timer was bad but I later learned that my defrost heater was also bad. Do yourself a favor and change both the defrost timer and defrost heaters. This issue is generally an age issue so replacing both will give you peace of mind. Also, clean the whole freezer as this is the time to do it. You will be surprised at the ice maker bucket cleanliness. Time to prepare and clean is what takes additional time. Time to repair is short and simple. One last thing, when replacing the defrost timer try not to mess with the temp. control slides as you will have to put them back in the proper positions for reassembly of the cover.

Solenoid pushing the crushed ice flapper was burned out. Solenoid was easy to find unplug and replace. I used the old piston which simplified things. Now works great

Ordered this part after i replaced the plastic tubes on the back as the problem persisted. loosen the nuts holding the water inlet lines, remove the cover to the valve. remove the valve and the water inlet line to the the valve. Disconnect the 2 outlets from the valve. 1 outlet to icemaker and other outlet to water cooler (bigger). Connect water inlet and 2 outlets to the new valve, test the water lines. Found the inlet is leaking, removed it and added teflon tape and reconnect it. All is done. Then I left the freezer door open for 3 hours to melt the ice on the wrong places and all is well.

Followed the online video exactly and it was easily done. Couldn't have been better. The problem is solved.

We watched the video and it was super easy! Once the circuit board was replaced, everything worked perfectly! Thanks so much for helping us keep this refrigerator in working order!