All Installation Instructions for Maytag Range CRE7900ADM

Replace bake element

Remove two Phillips head screws , detach element , replace with new one. Very simple

Parts Used:

Oven Bake Element

Patrick from Scituate, MA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers

Was this instruction helpful to you?

Thank you for voting!

My bake element burned up and broke

I ordered the part on a Monday morning and I had it on Tuesday. (I used regular shipping) Took out the oven racks and unscrewed the element. I pulled out the element about 4 inches and disconnected the wires, and removed the element. I made sure the wires were not burned and that the connectors looked good. They did. I simply connected the wires to the new element and screwed it back in place.

Parts Used:

Oven Bake Element

John from Milford, DE
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

Was this instruction helpful to you?

Thank you for voting!

oven temperature only goes to 275 degrees even when set higher; broiler works

I watched the video, which was very helpful...the temperature sensor was hard to pull through the small opening in the upper back left oven corner. On the back wall of the oven was a large removable circle, so I unscrewed that piece and was able to gain access to the wires attached to the temperature sensor and push it through the small opening. I used one of the new connectors, pushed it back through the small opening, screwed it back onto the oven wall, replaced the circle opening and tried the oven again...unfortunately, there was no improvement in oven temperature! My JennAir wall oven is about 17 years old, and I thought I would try this $30 repair prior to purchasing a new wall oven, but it looks like I will have to do some overtime and buy a new oven. Any other suggestions would be welcome.

Parts Used: