CDNT18V9A Admiral Refrigerator - Parts

Cold Control Thermostat The cold control thermostat works with both room air conditioner units and refrigerators. It cycles on and off regularly to keep your appliance cold. You should replace your thermostat is if your appl... Add to cart

Meat Drawer Support Rail - Left Side This left side meat drawer support rail is thirteen inches long. It is clear and made of plastic.

Meat Drawer Support Rail - Right Side This right side meat drawer support rail is thirteen inches long. It is clear and made of plastic.

Icemaker Fill Tube This fill tube grommet is used to supply water to the icemaker and is partially located in the refrigerator/freezer wall. Add to cart

Egg Tray This egg tray holds fourteen eggs. Add to cart

Ice Dispenser Engagement Yoke This ice dispenser yoke is an inch and a half long. It is made of metal and is used with the ice enclosure of a refrigerator's icemaker assembly. Add to cart

Defrost Heater

★★★★★

★★★★★

(1)

This radiant glass defrost heater is twenty and a half inches long. It comes with an instructions sheet, and is intended for use with the freezer evaporator of some refrigerators. Add to cart

Defrost Thermostat - With Wire and Clip This refrigerator defrost thermostat will cut out at 80 degrees Fahrenheit and kick back when the temperature drops to 15 degrees Fahrenheit. Add to cart

Screw Sold Individually.

Speed Nut The speed nut (also referred to as a condenser motor fan nut), fits onto the condenser fan motor. The motor for this fan turns on simultaneously with the evaporator and the compressor motors, so a mal... Add to cart

Ejector Arm This is an ejector arm, and it is used in conjunction with your refrigerator. The function of this part is to act as a cube ejector inside your ice maker. The arm will rotate inside the ice maker to a... Add to cart

Door Shelf Retainer Bar - Cut to Fit This cut-to-fit refrigerator door shelf retainer bar comes at twenty-seven inches long. It is made entirely of metal. Add to cart