ADB1500AWS10 Amana Dishwasher - Instructions

I unplugged the dishwasher under the sink. I opened the dishwasher up and took out the 12 screws holding the inside door facing on. I gently moved the door facing down towards the dishwasher to reveal the door locking mechanism at the top of the door. I unplugged the mechanism and plugged in the new one. I put the door back together the same way I had taken it apart. In all it took about 12 minutes. Works like a charm.

Routine repair. There are videos on the net that show exactly how to replace the filter unit. However, when you order the filter, order a replacement pump impeller. The impeller must be removed to remove the filter on this model. The impeller was stuck on the shaft, and I had to destroy it with the side cutter pliers to get it off. Before putting the new one on, clean the pump shaft thoroughly and lube the shaft with silicon lube or vaseline jelly. Clean the bottom of the water pan thoroughly, then reassemble. Then pour one cup of vinegar in the bottom of the dishwasher and run it with no dishes. This will clean the inside of the dishwasher.

Repair was very quick. Pop the lock on each rail endcap with a flathead screwdriver, remove endcap and set aside. One at a time, unclip each wheel from it's mount point and replace with new wheel, clipping it back into place. Once all four are done, reinsert the end caps and re-engage the locks (can be done by hand. Total repair time was maybe 5 minutes. Upper rack slides like new again.

Removed the broken wheels. Snapped the new wheels on and replaced the basket

eash as pie. snap them onto the piece of frame on the bottom rack and the problem is solved

Removed the panels and the part came right out. Easier than I thought. part came faster then expected.

Unscrewed 10 torx fasteners.Pulled inner door panel up to gain access to latch. Latch has both micro switches attached. Un plug switches, remove and replace door latch, button up and your done.

Install complete latch and handle assembly. Remove panel, disconnect wiring and install the assembly

Unplugged and shut off electrical breaker. Removed inside door panel. Used flat shank to open compartment housing control board. Connected each wiring harness individually from old control board to new control board as I went. At that point, I snapped new control board in place. Tightened door panel. Plugged dishwasher back in.....reset breaker. Works great.

Thank You PartSelect for making this repair project simple and stress free. The exploded diagram of the appliance was clear and consise. The parts list was very helpfull. Showing me which parts were the most replaced gave me the confidence to order, reducing the prospect of having to return items ( always a pain point ). Parts arrived in just a few days. Followed the instructions on the video. Dishwasher was back in operation in no time and passed an overly thourgh dish inspection. Your site is amazing and is on my favorites tool bar. Thanks Agian !!!

pulled dishwasher out to see where the leak was comming from . after seeing where it was leaking i searched for parts for jenn-air diahwasher. that when i read about the reviews on how to replace the float switch. it was very helpfull in being able to do the work myself and not having to pay a repairman.

I haven't gotten to our rental to get the job done yet but it should go real easy because the broken one came off real easy these should go on just as easy. Thanks again for the parts

I removed the leaking valve and installed the new one it was pretty easy

Unplugged the power cord and removed front toe kick panels. Used a small mirror to see the location of the screw holding the float switch in place and removed the screw, disconnected the float from inside the dishwasher removed the float switch and replaced. It was a simple repair and so far seems to have solved the leaking problem. There was some unusual wear to my old float and the switch looked like it may have been leaking a small amount as it had lime build up on the switch lever. The part came with an easy to follow instruction sheet. PartSelect has saved me money on repair work I thought I would not be able to do myself. The website is very helpful in resolving what he problem may be and what parts are needed. Fixed four other appliances using this site over the past few years and they ship quick.

Checked to see if the disposer was stuck or sprayers filled with food. They were clean so I listened and checked to see if the sprayers were spraying while the dishwasher was running. It was not. Checked online for answers and they said that there might not be enough water in the dishwasher since it did not fill appropriately. I added water during the cycle and then the sprayers were working properly until it drained and filled again. Installed the new water inlet valve and all works properly now.