A5892XRS Admiral Range - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Element caught fire and melted
two philips head screws and pull straight out about 6 inches unfasten wire connectors. Be careful not to let insulation catch fire when you reconnect the two slip on connectors. Put the two screws back in and you are done
Parts Used:
-
Maurice from Joshua Tree, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Cartridge wire burned out
I was unable to remove the screw which held the electrical element.. so I took the new surface burner receptacle and removed the metal part, and used the old one and put in the new one in the old metal part and rewired, and it is like new.. now I need to do another one.
Parts Used:
-
Robert from San Francisco, CA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
Oven would overheat
Followed directions as supplied. New part did not work, so it must be in the control unit which is no longer available. So time for a new range.
Parts Used:
-
MARK from roseville, MN
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Broken plastic knob
-
Judy from McKinney, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Replace bake element
Remove two Phillips head screws , detach element , replace with new one. Very simple
Parts Used:
-
Patrick from Scituate, MA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
My bake element burned up and broke
I ordered the part on a Monday morning and I had it on Tuesday. (I used regular shipping) Took out the oven racks and unscrewed the element. I pulled out the element about 4 inches and disconnected the wires, and removed the element. I made sure the wires were not burned and that the connectors looked good. They did. I simply connected the wires to the new element and screwed it back in place.
Parts Used:
-
John from Milford, DE
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!