Models > 7MMSE7999TW0 > Instructions

7MMSE7999TW0 Maytag Washer - Instructions

All Instructions for the 7MMSE7999TW0
271 - 273 of 273
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Washer agitator
I watched the video you all provided on the part it took only about 10-15 min to do the repair my old dog ears were gone. I ended up ordering the washer kit which was the best thing to do. Thanks for the fast deliverly I thought it was going to take longer but it was here in a day or two fast service. Thanks again for providing on the internet the video and the great service. Sincerely Mrs. Michele Harper
Parts Used:
Seal, Inner Cap Thrust Spacer
  • Michele from Leander, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Socket set
Was this instruction helpful to you?
Thank you for voting!
Spin cycle not working.
Almost identical to the instruction video that was sent. Very straight forward. I did not take apart the washer to identify the problem. I was short on time so I took a chance and ordered the highest probability cause of the symptoms indicated by your website. It was dead on; the problem is fixed. Parts were received ahead of schedule. Excellent all around.
Parts Used:
Clutch Assembly
  • Thomas from Brighton, MI
  • Difficulty Level:
    Easy
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Screw drivers, Socket set, Wrench set
Was this instruction helpful to you?
Thank you for voting!
Washer was not spinning clothes on 1st spin
After researching possible failure modes and reviewing a video for teardown/access from the control panel and access top down I noticed a lot of 'break dust' on top of the transmission. Shorting out the lid switch and putting my little finger on the drum, it would not spin but the clutch was spinning fine. I ordered a new clutch... Interesting thing when I was taking the clutch out... the gear it was attached to slid right off! After figuring out it was too big to go 'back' into the transmission and reviewing the parts explosion diagram... it BELONGED INSIDE THE TRANSMISSION! So I took the transmission cover off, poured out out the black-ish oil with metal filings in it, put the gear inside, filled it back up with 10W30, put the lid on, added the new clutch while it was apart and finished reassembly. Wow! It spins much better than when it was new. I guess never assume what can happen on an assembly line. Thanks for the great site.
Parts Used:
Clutch Assembly
  • Jeff from Westfield, IN
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 7MMSE7999TW0
271 - 273 of 273