Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 61-1093-10-00 > Parts

61-1093-10-00 Tappan Dishwasher - Parts

All parts for the Tappan Dishwasher 61-1093-10-00

Below is a list of all parts for the Tappan Dishwasher 61-1093-10-00 - 24" Built-in. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the 61-1093-10-00
1-14 of 154
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.73

Heating Element Brass Nut

The heating element nut is used to connect the heating element to the dishwasher tub. If water is leaking from underneath your dishwasher, you may need to tighten or replace the he...

$5.08

ROLLER TUB GREY

Sold individually. Grey in color.

$6.09

Upper Dishrack Roller and Axle Kit

The upper dishrack roller and axel kit comes with two pieces, a wheel and an axle. This kit is made for your dishwasher. Both pieces measure to be roughly one square inch each, the...

$24.82

Door Gasket

This tub gasket, also known as a door seal, is used for dishwashers. This one-piece part provides a water-tight seal between the dishwasher tub and door to prevent water leakage. If you find your dishwasher is leaking or the door will not close, replacing the door seal can solve the issue. The measurement for this door seal is 90 1/4 inches long. Remember to unplug the dishwasher from the power source before beginning this installation project. Refer to the manual provided by the manufacturer for installation instructions.

$18.30

Single Door Spring

NOTE: Sold individually. This door spring is four and a half inches long. It is used for some dishwashers. These springs tend to wear out at the same rate, so you should replace bo...

$20.09

BASKET

This is a basket for your dishwasher. It sits in the lower dishrack and holds small utensils during a washing cycle. This basket has six smaller sections where you can separate your cutlery into specific groups. This silverware holder is made entirely of plastic with a crisscross pattern allowing water and small food particles to pass through it during the cleaning process. This model is grey and roughly 14 inches long, about 6 inches high, and almost 4 inches thick.

$6.92

Pan Head Screw

Sold Individually. Order quantity required.

$21.82

Upper Dishrack Track End Cap

Sold individually.

$3.55

WASHER

$33.22

ARM ASSY

$28.45

Spray Tower Base

This tower base is located on the lower spray arm.

$7.00

Access Panel Screw - Black

Sold individually.

$2.88

THERMOSTAT

$0.73

SCREW

All Parts for the 61-1093-10-00
1-14 of 154