Models > 5521CH > Instructions

5521CH Husqvarna - Instructions

All Instructions for the 5521CH
1 - 4 of 4
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Cable was broke.
Pushed the cable through the engine mount.Connected the cable to the engine slider. Pulled cable through the previous tie down connected to the lower end of the bar. Attached the connector on the cable to the hole in the lawn mower bar near the top of the bar.. Attached the top end of the cable to the on/off bar where you push the mower.
Parts Used:
Engine Zone Control Cable
  • James from ASHTABULA, OH
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers
6 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
My self-propelled lawnmower did not function. The front wheel assist did not work.
I removed one of the wheels and noticed that the gear teeth were worn off. I then checked the other wheel and it was the same. I ordered two replacement wheels and replaced the worn wheels with the new wheels. It took less than 15 minutes to remove the old wheels and replace with the new wheels. It took a ratchet and a 9/16 inch socket. It was a very easy repair.
Parts Used:
Wheel
  • Russ from ALTENBURG, MO
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Socket set
9 of 15 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Worn high wheel rear bushings.
Remove 3/8 nut with a 9/16 wrench. Re move wheel from mower the remove old bushing clean. Install new bushings (2 piece bushings). Reinstall the wheel on to the mower.
Parts Used:
Kit, Bushing, High Wheel
  • Dennis from MILWAUKEE, WI
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Wrench set
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
I did not have a special wench
I mowed until gas was empty. No bottom plug had to turn mower on side and drained oil. I had buy special lubricants to remove blade bolt. That was a challenge. I called a friend to help place new blade on. Put in new filter, oil, and gas. Mower works great!
Parts Used:
Blade Adapter Blade Hardened Washer
  • Sharon from MCMINNVILLE, TN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Wrench (Adjustable)
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 5521CH
1 - 4 of 4