All Installation Instructions for Washer 4KMTW5755TW0

agitator "dogs" broken

followed video exactly and was up and running in less than an hour! Super fast delivery of correct parts and was out to dinner while washer was operating quietly once again. Thanks PartSelect - can always count on your services! WSD

Parts Used:

Direct Drive Water Pump

Agitator Repair Kit

Walter from West Palm Beach, FL
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers, Socket set, Wrench (Adjustable)

Was this instruction helpful to you?

Thank you for voting!

Extremely wild rocking in spin cycle

Followed the instructions given in the video. Exactly as per video instructions.WATCH THE INSTRUCTIONAL VIDEOS!!

Parts Used:

Tub Spring

Suspension Spring

Bryan from Midland, NC
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers

Was this instruction helpful to you?

Thank you for voting!

Agitator slipping

I take the little cap off the agitator then i use a socket with an extension to pull the bolt, I lift the agitator out the washer take off the old parts, and wash off the soap scum, then i install all the new parts and put the agitator back together, and put it back in the washer.now the washer is working fine.

Parts Used:

Agitator Repair Kit

Guy from New Castle, DE
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Socket set

Was this instruction helpful to you?

Thank you for voting!

There was a hole in the outer tub

I went to you tube and watched a video on how to take my machine apart.Everthing went great.I did need to buy a spanner for $23.00 @ an appliance store.

Parts Used:

Washer Outer Tub

Centerpost Gasket

Kevin from Boise, ID
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers, Socket set

Was this instruction helpful to you?

Thank you for voting!

Washer would stop during any cycle until lid is opened and closed.

Unplugged the washer. Removed the 2 screws on back of control panel. Pulled the control panel forward. Flipped the control panel back. Disconnected the cable from the lid switch. Removed the ground screw with a nut driver. Opened the washer lid. Removed the lid switch. Snapped the new lid switch into place. Closed the lid. Installed the ground screw. Installed the lid switch cable. Put the control panel back in place and pushed back. Installed the 2 rear screws into the control panel. Plugged the washer in.

Parts Used:

Washer Lid Switch

Edward from Denver, CO
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Washer would stop between cycles

I unplugged washer, then, removed the control panel with two screws on back, slid unit back and up. Unscrewed ground screw and unplugged harness, lifted lid and removed switch. In order to re-install lid switch, lid has to be in the up position, otherwise it will not fit properly. Reattach harness and ground screw, then control panel. Plug and go. My wife says that the washer works better than ever. Very easy! Saves money!

Parts Used:

Washer Lid Switch