41799465820 Kenmore Washer Dryer Combo - Parts

Rear Drum Bearing Kit

★★★★★

★★★★★

(104)

This rear drum bearing kit is designed for use with dryers. It supports the rear of the drum in your appliance as it tumbles your clothes during the drying cycle. If your drum will not tumble, or if i... Add to cart

Drum Support Bearing

★★★★★

★★★★★

(20)

If your dryer does not tumble, will not start, is noisy, or is leaving marks on your clothing, you may need to replace the drum support bearing. The drum is supported at the rear by a bearing, which a... Add to cart

Drive V-Belt

★★★★★

★★★★★

(28)

This rubber V-style drive belt slips on the motor pulley to bring the basket to the required speed. If you notice a burning rubber smell or grinding noises coming from your washer, your washer does no... Add to cart

Door Catch

★★★★★

★★★★★

(19)

The door catch on your dryer is an important part as it keeps your dryer door closed, in order to ensure no air or clothes can escape. This part works by holding the door strike, which allows the door... Add to cart

M Series Ignition Coil Kit

★★★★★

★★★★★

(24)

This kit contains two coils, one is a two-wire secondary coil and the other is a three-wire booster coil. Both coils in the ignition coil kit should be used together in the clothes dryer. Some of the ... Add to cart

Dryer Drum Bearing Bracket

★★★★★

★★★★★

(2)

This drum bearing bracket is for dryers. Drum bearing bracket holds and supports the drum bearing Add to cart

Water Inlet Valve

★★★★★

★★★★★

(12)

The water inlet valve has two ports for water to enter and controls the flow of water into a washing machine. Hot, cold, and warm water can easily enter the washer this way. If the water inlet valve i... Add to cart

Door Strike

★★★★★

★★★★★

(7)

The door strike is attached to the door of your dryer and holds the door closed. If your dryer door is not closing, this might be due to the door strike needing to be replaced. This is a simple repair... Add to cart

Tension Idler Pulley

★★★★★

★★★★★

(5)

The idler pulley on your washing machine allows the drive belt to operate smoothly. If your washer is not spinning or agitating, makes too much noise, or you notice a burning smell when it is operatin... Add to cart

Screw This is a replacement screw for your washer or dryer. The screw is approximately half an inch in length and is a Phillips-head screw. It screws in from the outside of the drum, into the vane/baffle. T... Add to cart

SCREW Sold individually. Add to cart

Flame Sensor

★★★★★

★★★★★

(4)

This part senses the flame for heat allowing the gas valve to open. The most common issue that might arise that would indicate the flame sensor needs to be replaced is your dryer is not giving off eno... Add to cart