3CAP2762BN0 Whirlpool Washer - Instructions

Replaced the clutch - works great. HOWEVER - check the drain pump attached to the motor, there was a small sock clogging it up which also fixed the problem. I saved 600 bucks on not buying a new washing machine!!

Parts came promptly. Disassemble agitator as per tutorial video on website. Replace locking "dogs" and reassemble. Cheap, effective fix!

disconnected power cord. disconnected water lines, pulled outer drain hose out of home drain standpipe. tilted unit forward. removed outer drain hose. removed mounting screw for drain pipe with nut driver. removed inner drain hose (defective part) with pliers. installrd new part in reverse order. new part fit like a glove.

Rubber O ring around the Inner Cap was rotted and busted through. Replaced with new Inner Cap Seal. Easy as pie!

take the cabinet frame out first, take the pump off the motor assembly, take motor out, found the coupling is broken. replace the coupling, put back everything. That's all. Washer start to work immediately.

Youtube video

Watched your You Tube channel video, and followed the steps. Simple. I do wish that you would reference the specific You Tube video with each parts kits that you sell. For example, if someone buys Part Kit 7654, they should get an insert telling them to watch You Tube video UYT.

I followed the easy to read instructions that came with the replacement parts. I didn't order the agitator grease. Didn't know it was needed. The repair was very easy. Parts arrived quickly. Fit perfectly. Washer is back in use. It's cheeper to fix it yourself if you can.

Watched the video on this sight. Fallowed instructions in video and everything went very smooth.

Unplugged, removed water supply hoses, removed drain hose from washer, laid whole washer on it`s back without removing the cabinet, popped clips off the water pump and laid to side, took two screws out of clips that hold motor on and popped them off with a screw driver, unplugged wiring harness and another single wire on motor and then lifted motor off. Then pried the plastic pieces of the coupling off the the motor and transmission shaft. Cleaned debris off motor and washer, replaced plastic piece to the transmission and set rubber part on plastic. Then replaced new plastic piece on motor and set motor back into bracket and put all parts back on in reverse order. I make it sound hard but was a easy job.

After watching the videos on how to complete the repairs, I ordered the parts. That next weekend I watched the videos again and from start to finish I was done in just under 1 hour. The most difficult part was getting the cabinet back on. The total cost to me was less than $45. Sure beats $600 plus for a new washer. And the next time, I'll order the double action lubricant for the agitator from Part Select. Buying that at the local appliance center was costly.

I followed the video on replacing the direct drive coupling. It was easy to follow and gave step by step instructions for screw locations, fastener and part removal and installation.

Used the kit supplied

The spin cycle was super slow leaving clothes soaking wet at the end of a full wash cycle. Ordered a clutch repair kit, watched the how to video that was e-mailed to me with my order while I did the repair and got it done in about 45 minutes. This was my first true appliance repair outside of maybe a busted fuse or replacing the heating element in a stove. Never thought taking the motor, transmission and clutch out of the washer and putting all back together would be so very simple. Meanwhile my wife is pissed because she thought she might be able to go get a brand spankin new washer...until I fixed the old one. Thanks for saving me some dough PartSelect.