2200 Poulan Chainsaw - Parts

Nut - Bar Mounting The OEM Mounting Bar Nut is a nut used to install a mounting bar to your machine. Installation requires a wrench set and socket set, and is rated as "Easy". This nut attaches to the chainbar studs. Add to cart

Carb Gasket/Diaphragm

★★★★★

★★★★★

(1)

Note: The beige piece pictured has been redesigned. It no longer has the four corner holes. It now only has 2 corner holes at a diagonal. Add to cart

Chain Catcher Add to cart

Pin - Bar Adjust This Bar Pin Adjuster is an OEM part used to adjust the tension on the bar, which loosens or tightens the chain. It attaches to the slot in the bar, and the chainsaw bar adjusting screw. Installation ... Add to cart

Clutch Drum and Gear Assembly Add to cart

Rope (3 ft.) The chainsaw starter rope is a three-foot-long white rope that is approved by the original equipment manufacturer, and which wraps around the recoil pulley and is pulled to start the engine. Installat... Add to cart

Assembly-Oil Cap w/ret.

Retainer - Bar Adjust This OEM bar adjustment retainer is a metal component that securely holds the adjustment screw and pin in place, allowing you to adjust the chain tension. It is typically located near the front of the... Add to cart

Washer-Clutch Add to cart

Rope Retain Screw This part is the rope retain screw for your outdoor power equipment. It is black in color and is a flathead screw. It is sold individually and is an authentic OEM part sourced directly from the manufacturer. Add to cart

Washer - Thrust

Screw Add to cart