1106817241 Kenmore Dryer - Instructions

I watched the repair video on your website,that was abig help , dryer runs good

Just like the instructions. Piece of cake.

First off, I ordered the part around 1 pm, paid regular shipping, and it was here the very next day! As for the repair, maybe the easiest fix I have done. Make sure the dryer is unplugged, pop the top up and remove the front of the dryer. Take out the pulley (careful it can snap ya) then remove the drum. The snap rings around the motor can be tricky, so be sure to watch the video sent to you from PartSelect. With a couple of wrenches, loosen the motor from the blower and remove. Put new one in and put back together. Piece of cake. Took me about 20-25 mins. This is the best place I've ordered from and will continue to get my supplies here. Good Luck!

This dryer refuses to die and I am happy to keep it that way. Door latch was replaced in less than a minute using this kit. Easiest repair ever.

took top off,took back off,took lower panel off,removed old motor without taking drum out,got the part # off old motor,looked it up on line then i found the video on how to do the repair...lol. The repair went well and the instructions that came with the new motor were very good as my motor had the old style switch and needed to be rewired. I did go one step further as long as i had it that far apart,I took the duct work apart on the back of the dryer for the vent and I was very glad I did,it had 25 years of lint and all sorts of other thing in it.I cleaned and lubed all other moving parts and reassembled,works and sounds like new !

Slipped screwdriver on top and bottom of catch and pullef out. Pressed new catch in plact. Job finished.

I watched the informative video you sent via e-mail with order conformation. Installation was flawless. Thanks and will be using your site again for any other small appliance repairs that may need my attention.

This repair took me longer because I was just giving it a try - I have no experience, although I tend to be "handy." I'm sure anyone with experience would rate this as "easy" and have taken only a short time. I had to watch the video several times to understand what to do - and the comments were helpful too. My washer is an OLD maytag, so I removed the front of the dash and pulled it forward to access the electronics. My switch had only 2 prongs, so I hooked up to the "lid closed" option on the new switch. It works perfectly now. Very pleased I gave it a try.