All Installation Instructions for Kenmore Refrigerator 10653204202

On the back of shelf the snap catches broke .

Removed broken shelf and snapped in new one

Parts Used:

Refrigerator Door Shelf

Scott from Oconomowoc, WI
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

Freezer not freezing food

remove power. Remove rear cardboard panel.. Remove wiring from startup kit. Remove defective startupup kit. Then reverse procedure.

Parts Used:

Compressor Start Device Kit

conrad from LaPlace, LA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

Was this instruction helpful to you?

Thank you for voting!

Freezer was cold refrigerator was too warm.

I knew that if my freezer temp seemed Ok and my refrigerator was too warm that I should be looking to see if my evaporative fan was working. It blows the cold air from the freezer through to the refrigerator. Turns out that the unit was working and I figured out by viewing other customer experiences there was a diffuser door that opens and closes with a thermostat that was not operating. Replaced it and everything is fine.

Parts Used:

Air Diffuser

Larry from Hatboro, PA
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Ice maker quit working

I found the part I needed at parts select and followed the video on their web site. They have a very informative web site, it made my job easy. I highly recommend this company.

Parts Used:

Icemaker Control Assembly

Donald from Banning, CA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Ice Maker would not make ice

A repairman wanted $600.00 to fix our ice maker. I paid him $88.00 for his "service call" & asked him to leave. I ordered & replaced the ice maker machine & the ice maker still would not work, so I replaced the 2 optics boards next. Replacing the ice maker was most challenging because the plug is so hard to get at, but the 2 optics boards were pretty easy. Just watch the video on PartSelect.com. Work slowly & take your time when pulling out & replacing the optics boards. There were a total of 6 screws for the 2 optics boards. It took me approximately 10 minutes to replace both boards, & now my ice maker is working perfectly! I am thrilled!!

Parts Used:

CNTRL-ELEC

KATHRYN from BOISE, ID
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Ice Maker stopped working. Already replaced Photo Eye

Top left mounted Icemaker facing front. Disconnect power to fridge. Using 1/4" nut driver remove single silver nut under right rear side. It holds a plastic cover over the electrical connection, unhook the cover and remove it. Release clips under front lip under both sides and entire icemaker will slip and twist out. Remove electrical connection to ice tray. Place assembly on bench and remove 3- 1/4 hex screws from under side to release bottom tray. Snap cover off motor and remove. Carefully align pin and arm on control assembly to ice tray and-re assemble. May take 30 min to dispense. Discard till clear.

Parts Used:

Icemaker Control Assembly

Alfred Van from Lutz, FL
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

Was this instruction helpful to you?

Thank you for voting!

None

Watched the video it was right on, no problem.

Parts Used:

CNTRL-ELEC

Roger from Hampton, CT
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

overloads melted

installed o/l unit which was #1 on instruction sheet ,very easy, pluged side by side refrigerator freezer in ac outlet, checked amps on compressor, and a very happy ending! THANKS!

Parts Used:

Compressor Start Device Kit

albert from westwego, LA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

Was this instruction helpful to you?

Thank you for voting!

refrigerator and freezer would stay frozen.

I shut the unit off for about ten hours and when I turned it back on and set the temperatures for the freezer and refrigerator it has been working great.I will keep the part in case it happens again.

Parts Used: