10652603100 Kenmore Refrigerator - Instructions

I looked on line to see repair instruction videos on my refrigerator ice maker. When I saw how easy I went to PartSelect and order the part (control and motor assembly). I received the part in two days with the cheapest shipping option. My 33 yr old son was visiting when the delivery was made. After we opened the box, he went to the basement for tools and the rest is history. 10 minutes work and ice a couple of hours later! No problems since.

This was easier than I made it. remove air diffuser cover at the top side of the freezer. remove air deffuser by closeing clips on freezer side. disconnect the power supply. reverse procedure. not real specific but you can figure it out I know you can.

Pulled out the old unit removed 3 screws waited about 3-4 hours had ice. Took over night until we were actually sureby then the ice bin was full. Easy repair!

I found the part I needed on this website, watched the tutorial and saw how simple it was to do myself. I ordered the part and it arrived within a few short days. It took me no more than 15 minutes to change out the part. I saved myself several hundred dollars. It is rather shocking how much the "professionals" charge considering the cost of parts, labor and nominal service fees.

simply replace the compressor start and delay

what I discovered is the condenser fan is still operating but not strong another word insufficient cooling for the condenser. therefore, it's getting too hot and shutting off and stripped the circuit breaker. After installing the new condenser fan, it gets back in business. it's quite simple. Just unplug the unit off, uncover the bottom back cover and there you see compressor, condenser fan and other good stuff. there you unscrew the nut in front of the condenser fan and remove the fan, then it expose the two screws that holding the fan motor, remove these screws and take out the motor. and just install the new fan motor kit in and there you have it. plug it back to the wall and there it goes

Easy repair once you figure out how the door is assembled. Note there are two replacement parts supplied in the kit. You only need one, but.... don't throw anything away yet, we have a special use for the extra part. 1) Pull the surround to reveal the mounting point for the dispenser. There is an inner panel that has a couple screws that needs to come out. 2) Disconnect the switch plate from the harness. Ensure you have the wire colors written down. My fridge had them marked on the switch, but be sure to check first. 3) Disconnect the water line under the door. Instructions show a threaded coupling, but mine was a press fit. Easy to undo, just put pressure on the collar at the union, then pull the tube out. 4) Remember the extra tube in the kit? This is where to use it. The tube in the door follows a channel down to the door hinge. However, it sometimes hangs up on the hinge ferrel, which means you have to pull the door to fish it out. To avoid having to pull the door, use the extra tube as a "fish tape." String or twine works just as well. Tape (duct tape, electrical tape, etc.) the end of the old tube to the extra tub supplied in the kit. You can tell which one by comparing the nozzle ends, they are different. You want this tape joint to be smooth without a big bulge. 5) Remove the screw holding the old nozzle and gently pull the old nozzle and tube from the door. 6) Disconnect the old tube from the extra tube, then connect the new replacement tube to the extra tube. 7) Carefully draw the new tube into the door. 8) Disconnect the extra tube from the new tube and reconnect the new tube to the water line. 9)Mount the nozzle, re-install the inner panel, re-connect the switch assembly, then reassemble the surround.

I've tried ordering the part from Sears and they told me it will take about 7 days for the part to arrive, some other place said it will overnite for extra money. So I've ordered the part from Part Select at a good price and prompt delivery. once the part arrive installing the part so so easy cause it had easy to follow instructions.

I simply followed the step by step instructions demonstrated in the online videos for replacing the electronic control boards - emitter and receiver. Just that simple. 15 minutes later the repairs were completed. We've had ice ever since.

I checked the trouble shooting guide with the refrigerator and all signs pointed to the Electronic control boards that sense when the ice tray is full. After reading what other customer posted on this site I ordered the parts. I received the parts in two days time and had a harvest of ice within minutes of installing it. Thanks PartSelect. Scott

repair was not to bad. removed 3 screws, then unplug wire harness. The next thing i did was removed clip that holds pin. slid pin back enough to put new flipper in place. needs to go in front of spring.once in place slid pin back in and put clip holder back on. Then plug wire harness back in and 3 srews . done.

With the flat screwdrivers, table knife or something to pull the front cover, is not easy but it will come out, patient and kepp trying until you made it, the rest is easy.

It was a no brainer just snap the piece on. The Parts select service is great have bought parts here before and prompt delivery great place to get parts

Took old drawer out, put new drawer in. When I first opened the new drawer I was a little disappointed as the printing on the edge of the crisper (where it says humidity low-high) was a different color than my existing drawer, I know it's such a small detail that nobody would notice but me. My fridge is almost brand new and I'm the one who broke the drawer so I was a little sad but then realized that I could remove the edge of the drawer and replace it with my old one... VIOLA brand new drawer with purple letters! The drawer itself came so fast, I believe it was 1-2 days to my door! Thank you Part Select

Ps328747 icemaker and water dispenser dual inlet valve was purchased from parts select. My wife, sandy, watched install video provided by parts select on their website. Sandy used plywood to protect our hard wood floor. She pulled out the refrigerator (she did need my help to do this task). Unplugged the refrigerator. I turned off water line in the basement. Sandy followed the video to the tee. Fifteen minutes later the part was installed. The ice maker tray was quickly filled with water. Ice cubes quickly were made. My wife is uniquely talented. Last winter, she remodeled two bathrooms in our naples home replacing all the fixtures, vanities, flooring, etc. My wife can do almost any task. Many years ago, I had a leaking radiator and a broken arm at the same time. What did she do--she removed the radiator from the car, took it the repair, and reinstalled the repaired radiator. Sandy plays tennis, golf, brige, hikes, sings in the church choir, works at theater as a red coat, and at 62 years of age, she tackled another item on her bucket list in january 2012. Sandy's first recital is saturday--she is quiet an accomplished pianist already. I could relate many other stories about her but the most important one is that this beautiful woman has been wife for 43 years and the mother of our two beautiful daughters, jessica and holly.